User's Manual

Table Of Contents

AGRAS MG-1 User Manual

a) There is a ditch or reservoir nearby;

b) There are large height gaps between different surfaces;

c) Flying at high speeds. When flying speed is below 5 m/s, the height gaps should not exceed 1 m;

when flying speed is over 5 m/s, users should be aware of the distance between the aircraft and the

surface measured to avoid accident;

d) Flying over moving surfaces or objects;

e) Flying over surfaces that can absorb sound waves (e.g., excessively dense vegetation of small leaves,

planted turf, ferrite coating);

f) Flying over surface with large inclination (15



at a flying speed of 1 m/s, 6



at a flying speed of 3 m/s,



at a flying speed of 5 m/s).

Radar Status Indicator

The Radar Status Indicator shows the current status of the Altitude Stabilization System. See the table below:

Blinking Pattern

Description

Solid Green

Warm up.

Blinking Green

Working properly.

Off

Not working.

No Liquid Warning

Profile

When there is no liquid in the liquid tank, the Liquid Level LED on the Operation Status Display Panel blinks red. The

aircraft movement varies in different operation modes: it will ascend for 3 meters and hover automatically in Smart

Operation Mode, and it will hover in place in Assisted Operation Mode and Manual Operation Mode.

Use

1. Press the Spray Button on the remote controller to turn off the sprinklers manually when in Manual Operation

Mode. Otherwise, pump motor idling will accelerate its aging and wearing and spraying after adding liquid can

cause damage(s) or injuries. The aircraft will turn off the sprinklers automatically when in Smart Operation Mode

or Assisted Operation Mode.

2. Ensure the aircraft is in Manual Operation Mode, and then land the aircraft and stop the motors. Add liquid to

the liquid tank and tighten the cover.

3. Press the Spray Button on the remote controller to discharge the air in the pump until the liquid level LED on the

Radar Status Indicator