SZ DJI TECHNOLOGY AGRAS MG-1 : User's Manual : Page 26

AGRAS MG-1 User Manual

Flight

Starting and Stopping the Motors

The Combination Stick Command (CSC) listed below is used to start/stop the motors. Ensure you perform the CSC

in one continuous motion.

Starting the Motors

Perform the CSC command. The motors will begin to speed at an idle speed. DO NOT perform the CSC command if

you will not fly the aircraft within a short time. Otherwise the aircraft may drift which can cause damage or injuries.

CSC 1 CSC 2 CSC 3 CSC 4

Stopping the Motors

There are two methods to stop the motors.

Method 1: When the M100 has landed, push the throttle stick down, then perform the CSC command to stop the

motors. Release both sticks once the motors have stopped.

OR OR

Method 2: When the aircraft has landed, push the throttle down and hold. The motors will stop after 3 seconds.

Method 2 is not available for stopping the motors when the Flight Mode Switch is toggled to Manual Flight Mode

and it is set to Manual not Attitude.