User's Manual

AGRAS MG-1 User Manual
© 2016 DJI. All Rights Reserved. 6
2. Prepare hose clamps A. Tools such as pincers may be required. Follow the instructions below to connect the other
end of the hose to the liquid pump.
①
Pull the hose through the hose clamp A and then connect it to the fitting of the liquid pump.
②
Open the hose clamp A by tools such as pincers. Move it to the fitting and release the hose clamp A to grip the
hose.
3. Prepare hose clamps B and M3x6 screws to fix the hoses to the arms and landing gear.
①
Open the hose clamp B to an appropriate angle to hold the hose. DO NOT damage the clamps.
②
Tighten one M3x6 screw to the hose bracket on the landing gear.
③
Tighten one M3x6 screw to the mounting hole on the bottom of the frame arm junction.