User's Manual

AGRAS MG-1 User Manual
© 2016 DJI. All Rights Reserved. 7
Mounting the Radar-Assisting Altitude Stabilization System
1. Arrange the side with a DJI logo outwards.
2. Align the mounting holes on the liquid tank and altitude stabilization system. Then tighten two M3x8 screws.
3. Align the slot inside the radar cable connector and fin of the radar port on the center frame. Plug the cable and
then rotate the upper part of the cable to the left to insert it into the slot on the cable port.
Connecting the Batteries
There are two XT90 ports on the aircraft. The allowable voltage is 22.2 V for every XT90 port. Connect two 6S
batteries in series to get a maximum power supply of 50.4 V.
Battery Use Requirement:
1. Be sure to use two 6S LiPo batteries of the same model. 6S LiPo batteries of 12000 mAh capacity and 10C
continuous discharging rate are recommended.
2. Ensure that the voltage of the two batteries used is the same.
3. The two batteries must be used together all the time. Replace the two batteries together for safe use, if one of
them is damaged.
Batteries are required but not included with the MG-1.
The batteries for the MG-1 are of high voltage and energy. Use them in accordance with their
instructions and make safety your top priority. DJI assumes no liability for damage(s) or injuries
incurred from using batteries.
Radar Cable
Radar Port