User's Manual

© 2017 DJI All Rights Reserved. 4
Remote Controller
1 Antennas
Relays the aircraft control signals.
2 Display Device
With Android system to run DJI MG-1S app.
3 Speaker
Audio output.
4 Control Sticks
Controls the aircraft movement. Can be set to
Mode 1 or Mode 2, or to a custom mode.
5 Power Button
Used to turn the remote controller on and off.
6 Status LED
Indicates whether the remote controller is linked
to the aircraft.
7 Battery Level LEDs
Display the current battery level.
8 RTH Status LED
Circular LED around the RTH button which
displays the RTH status.
9 Operation Mode Switch
Used to switch between Smart, Manual and
Manual Plus Operation Mode.
10 RTH Button
Press and hold this button to initiate Return-to-
Home (RTH).
11 Micro USB Port
Reserved.
12 Micro SD Card Slot
Provide extra storage space for the display
device, maximum supporting 128 GB.
13 CAN Port
Used to connect other accessories, such as a GPS
module.
14 USB Port
USB device support.
15 Spray Rate Dial
In Manual Operation Mode, turn the dial to
adjust the spray rate.
16 Spray Button
In Manual Operation Mode, press to start/stop
spraying.
17 Flight Mode Switch
Used to switch between P-mode (Positioning), A-
mode (Attitude) and M-mode (Manual).
18 Sleep/Wake Button
Press to sleep/wake the screen, press and hold to
restart.
19 Microphone
Reserved.
20 Button A
Records Point A of the operation route.
21 Button B
Records Point B of the operation route.
22 Flying Speed Dial
In Smart Operation Mode, turn and press the dial to
adjust the flying speed.
23 Button C1
Press to choose operation route L for Smart
Operation Mode.
In Manual Plus Operation Mode, press to fly the
aircraft left for one operation gap.
24 Button C2
Press to choose operation route R for Smart
Operation Mode.
In Manual Plus Operation Mode, press to fly the
aircraft right for one operation gap.
25 Button C3
In Manual Operation Mode, press to use only the
front two sprinklers.
26 Button C4
In Manual Operation Mode, press to use only the rear
two sprinklers.
27 Power Port
Connects to a power source to charge the remote
controller’s internal battery.