User's Manual

© 2017 DJI All Rights Reserved. 10
Operation Procedure
Maintain line of sight of the aircraft at all times.
Ensure that the Flight Mode Switch is toggled to the “P” position and the GPS signal
is strong. Otherwise, Smart Operation may be unreliable.
Always inspect operating environments before flying.
Ensure that Flight Mode Switch on the remote controller is toggled to the “P” position and a
strong GPS signal is present. In addition, ensure that the Operation Mode Switch on the remote
controller is toggled to the “M” position.
1. Record Points A and B in Order
Users cannot toggle the Operation Mode Switch to Smart Operation Mode unless points A and B
are recorded.
Fly the aircraft to the starting point, depicted as Point A (B), hover, and then press Button A (B) on
the remote controller. The Aircraft Status Indicator will blink red (green) after the starting points
have been recorded.
Points A and B cannot be recorded if the spray tank is empty.
Update Point B by flying the aircraft to a new position and record this position. Note that
if a Point A has been updated, then Point B is also required to be updated accordingly.
It’s recommended to keep the direction of Point A to B parallel to one side of the
rectangular spray area for optimal effect.
2. Select the Route
Press Button C1 or Button C2 on the remote controller to select the operating pattern. Press Button
C1 for Route L and Button C2 for Route R. The default route pattern is Route R, if no selection has
been made.
The route can be selected only in Manual Operation Mode. If the aircraft is in Smart
Operation Mode, select the route after switching to Manual Operation Mode.
Operation Gap
Turning Point
Route L Route R Legend