Phantom 3 Professional User Manual Map User can view the current flight route in a larger map view in this page. You can also perform Auto takeoff and Landing in the page. Ensure your mobile device has access to the Internet. Due to the map data required, Wi-Fi connection is recommended. Internet access is required to cache the map, if Wi-Fi is unavailable, mobile data service is required. Academy Download user manual, view tutorial videos and practice your flight skills using the simulator in this page.
Flight This chapter describes the flight safety and flight restrictions. 40 © 2015 DJI. All Rights Reserved.
Flight Once pre-flight preparation is complete, it is recommended to use the flight simulator in the DJI Pilot App to practice the flight skills and learn to fly safely. Ensure that all flights are carried out in a wide open area. Flight Environment Requirements Flight Limits and Flight Restriction Area All unmanned aerial vehicle (UAV) operators should abide by all regulations from such organizations as the ICAO (International Civil Aviation Organization), FAA and their own national airspace regulations.
Phantom 3 Professional User Manual GPS Signal Strong Blinking Green Flight Limits DJI Pilot App Aircraft Status Indicator Maximum Flight Altitude Aircraft's altitude cannot exceed the specified value. Warning: Height limit reached. None. Max Radius Flight distance must be within the max radius. Warning: Distance limit reached. Rapid red flashing when close to the max radius limit.
Phantom 3 Professional User Manual Safety Zone 1640 feet 66 feet 1 mile R1 R2 320 feet 1640 feet 66 feet 1 mile 320 feet R1 R2 Category B Safety Zone 100m 100m R R © 2015 DJI. All Rights Reserved. 43 Flight (1) Category B “safety zone” is comprised of a “no-fly zone” and a “warning zone”. (2) R mile around the safety zone is a designated “no-fly zone”. The value of R is determined by the size of the airport. (3) A “warning zone” has been set around the safety zone. When you fly within 0.
Phantom 3 Professional User Manual GPS Signal Strong Zone No-fly Zone Flight Restrictedaltitude flight zone Warning zone Free zone Blinking Green Restriction DJI Pilot App Prompt Motors will not start. Warning: You are in a No-fly zone. Take off prohibited. If the aircraft enters the restricted area in A mode but P mode activates the aircraft will automatically descend to land then stop its motors after landing. Warning: You are in a No-fly zone, automatic landing has begun.
Phantom 3 Professional User Manual Preflight Checklist 1. 2. 3. 4. 5. 6. Remote controller, Intelligent Flight Battery, and mobile device are fully charged. Propellers are mounted correctly and firmly. Micro-SD card has been inserted if necessary. Gimbal is functioning as normal. Motors can start and are functioning as normal. DJI Pilot app connected to the aircraft. Calibrating the Compass IMPORTANT: Make sure to calibrate the compass in every new flight location.
Phantom 3 Professional User Manual 3. Hold the aircraft vertically with nose pointing downward, and rotate it 360 degrees around the center axis. Recalibrate the compass if the Aircraft Status Indicator show solid red. Flight If the Aircraft Status Indicator blinks red and yellow after the calibration, move your aircraft to a different location to calibrate the compass. Calibrate the compass before each flight. Launch DJI Pilot App, follow the on-screen instruction to calibrate the compass.
Phantom 3 Professional User Manual Use auto-landing to land your aircraft automatically if the Aircraft Status Indicator displays blinking green. Follow the steps below to use auto-landing: 1. Ensure the aircraft is in “P” mode. 2. Check the landing area condition before tapping “ ”, to perform landing. Starting/Stopping the Motors Starting Motors A Combination Stick Command (CSC) is used to start the motors instead of simply pushing the stick up.
Phantom 3 Professional User Manual When the Aircraft Status Indicator blinks yellow rapidly during flight, the aircraft has entered Failsafe mode. A low battery level warning is indicated by the Aircraft Status Indicator blinking red slowly or rapidly during flight. Watch video tutorials about flight for more flight information. Video Suggestions and Tips 1. 2. 3. 4. 5. 6. 7. Go through the checklist before each flight. Select desired gimbal operation mode in the DJI Pilot app.
FAQ © 2015 DJI. All Rights Reserved.
Troubleshooting (FAQ) FAQ 50 © 2015 DJI. All Rights Reserved.
Appendix © 2015 DJI. All Rights Reserved.
Appendix Specifications Aircraft Weight (Battery & Propellers Included) 1284 g Max Ascent Speed 6 m/s Max Descent Speed 2 m/s Max Speed 16 m/s (ATTI mode, no wind) Max Flight Altitude 6000 m Max Flight Time Approximately 24 minutes Operating Temperature 0°C to 40°C GPS Mode GPS/GLOSNASS Gimbal Controllable Range Pitch - 90° to + 30° Vision Positioning Appendix Velocity Range Below 8 m/s (2 m above ground) Altitude Range 5 cm-300 cm Operating Environment Brightly lit (lux > 15) pat
Phantom 3 Professional User Manual Remote Controller Operating Frequency 2.400 GHz-2.483 GHz Transmitting Distance 2000 m (Outdoor And Unobstructed) Video Output Port USB Operating Temperature Range 0°C- 40°C Battery 6000 mAh LiPo 2S Mobile Device Holder tablet and phone Working Voltage 1.2 A @7.4 V Charger Voltage 17.4 V Rated Power 100 W Intelligent Flight Battery ( PH3-4480 mAh-15.2 V ) 4480 mAh Voltage 15.
Phantom 3 Professional User Manual Intelligent Orientation Control (IOC) IOC allows users to lock the orientation of aircraft in different fashions. There are three working modes for IOC and you may select the desired IOC modes from the DJI Pilot app. IOC only works under F mode, and user must toggle the flight mode switch to Position 1 to activate IOC.
Phantom 3 Professional User Manual FCC Compliance FCC Warning Message Any Changes or modifications not expressly roved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Phantom 3 Professional User Manual KCC Warning Message “해당무선설비는 운용 중 전파혼신 가능성이 있으므로 인명안전과 관련된 서비스는 할 수 없습니다 .” “해당 무선설비는 운용 중 전파혼신 가능성이 있음” NCC Warning Message 低功率電波輻射性電機管理辦法 第十二條經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加 大功率或變更原設計之特性及功能。 第十四條低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應改善至無 干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法 通信或工業、科學及醫療用電波輻射性電機設備之干擾。 Appendix 56 © 2015 DJI. All Rights Reserved.
The content is subject to change. Download the latest version from http://www.dji.com/product/phantom3 If you have any questions about this document, please contact DJI by sending a message to DocSupport@dji.com. © 2015 DJI. All Rights Reserved.
