Phantom 4 Pro/Pro+ User Manual Status LED Alarm Remote Controller Status — Solid Red Chime The remote controller is disconnected from the aircraft. — Solid Green Chime The remote controller is connected to the aircraft. Slow Blinking Red D-D-D...... Remote controller error. / Red and Green/ Red and Yellow Alternate Blinks None HD downlink is disrupted. RTH LED Sound Remote Controller Status — Solid White Chime Aircraft is returning home. D...
Phantom 4 Pro/Pro+ User Manual 4. The remote controller is ready to link. The Remote Controller Status Indicator blinks blue and a beep is emitted. RC Control Setting RC Calibration Stick Mode Searching for aircraft frequency, Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled. timeout in 54 seconds Do not change unless familiar with your new mode.
Camera and Gimbal This section provides the technical TQFDJmDBUJPOT PG UIF DBNFSB BOE explains the gimbal’s operation modes. © 2016 DJI. All Rights Reserved.
Camera and Gimbal &DPHUD 3URÀOH The on-board camera of Phantom 4 Pro/Pro+ uses the 1 inch CMOS sensor to capture video (up to 4096x2160p at 60fps) and 12 megapixel stills. You may choose to record the video in either MOV or MP4 format. Available picture shooting modes include burst, continuous, and time-lapse mode. A live preview of what the camera sees can be monitored on the connected mobile device via the DJI GO app.
Phantom 4 Pro/Pro+ User Manual Camera Operation Use the Shutter and Video Recording buttons on the remote controller to shoot the images or videos through the DJI GO app. For more information about how to use these buttons, refer to “Controlling the Camera Page 31”. Camera LED Indicator Camera LED Indicator lights up after the flight battery is powered on. It provides information on the working status of the camera. Camera LED Indicator Camera status System is warming up. Green Blink Once (0.5s off, 0.
Phantom 4 Pro/Pro+ User Manual Gimbal Operation Modes Two gimbal operation modes are available. Switch between the different operation modes on the camera settings page of the DJI GO app. Note that your mobile device must be connected to the remote controller for changes to take effect. Refer to the table below for details: Follow Mode The angle between gimbal’s orientation and aircraft’s nose remains constant at all times.
DJI GO app This section introduces the four main functions of the DJI GO app. © 2016 DJI. All Rights Reserved.
DJI GO App 5IF %+* (0 BQQ JT B NPCJMF BQQMJDBUJPO EFTJHOFE TQFDJmDBMMZ GPS %+* FRVJQNFOU 6TF UIJT BQQ UP DPOUSPM the gimbal, camera, and other aircraft functions. The app features Equipment, Editor, Explorerand Me TFDUJPOT XIJDI BSF VTFE GPS DPOmHVSJOH ZPVS BJSDSBGU FEJUJOH BOE TIBSJOH ZPVS QIPUPT BOE WJEFPT XJUI others. It is recommended that you use a tablet for the best experience.
Phantom 4 Pro/Pro+ User Manual [1] System Status : Indicates the current aircraft system status and GPS signal strength. [2] Battery Level Indicator : Describes the battery level of the aircraft according to its immediate status. The colored zones represent the various stages of battery level. When the battery level drops to a certain stage, the system will prompt the user to take the appropriate action.
Phantom 4 Pro/Pro+ User Manual Camera Settings : Tap this icon to set the ISO, Shutter Speed and Exposure Value of the camera. [10] Mini Map %JTQMBZT UIF nJHIU QBUI PG UIF DVSSFOU nJHIU 5BQ UIF .JOJ .BQ UP TXJUDI CFUXFFO $BNFSB 7JFX BOE Map View. [11] Flight Telemetry DJI GO App H: 39M V.S 2.3 M/S D: 210M H.S 4.2 M/S 232M Flight Attitude and Radar Function: 5IF BJSDSBGU T nJHIU BUUJUVEF JT JOEJDBUFE CZ UIF UBSHFU MJLF JDPO (1) The red arrow shows which direction the aircraft is facing.
Phantom 4 Pro/Pro+ User Manual [15] Auto Takeoff/Landing / : Tap to initiate auto takeoff or landing. [16] Livestream : This icon indicates the current video feed is being broadcast live on YouTube. Ensure that mobile data service is available on your mobile device. [17] Back : Tap this icon to return to the main menu. Editor SkyPixel Find out about our latest events, featured products and trending Skypixel uploads in the Explore page.
Flight 5IJT TFDUJPO EFTDSJCFT TBGF nJHIU QSBDUJDFT BOE nJHIU SFTUSJDUJPOT 48 © 2016 DJI. All Rights Reserved.
Flight 0ODF QSF nJHIU QSFQBSBUJPO JT DPNQMFUF JU JT SFDPNNFOEFE UIBU ZPV VTF UIF nJHIU TJNVMBUPS JO UIF %+* (0 BQQ UP IPOF ZPVS nJHIU TLJMMT BOE QSBDUJDF nZJOH TBGFMZ &OTVSF UIBU BMM nJHIUT BSF DBSSJFE PVU JO BO PQFO area.
Phantom 4 Pro/Pro+ User Manual GPS Signal Strong Blinking Green Flight Limits DJI GO app Aircraft Status Indicator Maximum Flight Altitude Aircraft's altitude cannot FYDFFE UIF TQFDJmFE WBMVF Warning: Height limit reached. None. Max Radius Flight distance must be within the max radius. Warning: Distance limit reached. 3BQJE SFE nBTIJOH when close to the max radius limit.
Phantom 4 Pro/Pro+ User Manual GFFU GFFU NJMF GFFU 3 3 Restricted Area N 3 © 2016 DJI. All Rights Reserved. 51 Flight 3FTUSJDUFE "SFBT EPFT OPU IBWF nJHIU BMUJUVEF SFTUSJDUJPOT (2) R miles around the designated restriction area is a Take-off Restricted area. Aircraft cannot take off XJUIJO UIJT [POF 5IF WBMVF PG 3 WBSJFT CBTFE PO UIF EFmOJUJPO PG UIF SFTUSJDUFE BSFBT (3) A “warning zone” has been set around the Restricted Area. When the aircraft approaches within 0.
Phantom 4 Pro/Pro+ User Manual GPS Signal Strong Zone /P nZ ;POF Flight RestrictedBMUJUVEF nJHIU zone Warning zone Free zone Blinking Green Restriction DJI GO app Prompt Motors will not start. Warning: You are in a No-fly zone. Take off prohibited. If the aircraft enters the restricted area in A-mode, but is switched to P-mode, the aircraft will automatically descend, land, and stop its motors. 8BSOJOH :PV BSF JO B OP nZ [POF Automatic landing has begun.
Phantom 4 Pro/Pro+ User Manual Calibrating the Compass Only calibrate the compass when the DJI GO app or the status indicator prompt you to do so. Observe the following rules when calibrating your compass: DO NOT calibrate your compass where there is a chance of strong magnetic interference, such as magnetite, parking structures, and steel reinforcements underground. DO NOT carry ferromagnetic materials with you during calibration such as cellular phones.
Phantom 4 Pro/Pro+ User Manual 4. Re-calibrate the aircraft if the aircraft status indicators blink red. If the Aircraft Status Indicator blinks red and yellow after the calibration procedure, move your aircraft to a different location and try again. $BMJCSBUF UIF DPNQBTT CFGPSF FBDI nJHIU -BVODI UIF %+* (0 BQQ BOE GPMMPX UIF PO TDSFFO instructions to calibrate the compass. DO NOT calibrate the compass near metal objects such as a metal bridge, cars, scaffolding.
Phantom 4 Pro/Pro+ User Manual Starting/Stopping the Motors Starting the Motors A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom inner or outer corners to start the motors. Once the motors have started spinning, release both sticks simultaneously. OR Stopping the Motors OR Method 1 Method 2 6WRS WKH PRWRU PLG ÁLJKW Pull the left stick to the bottom inside corners and press the RTH button at the same time. Only stop the PRWRUV PLG ñLJKW LQ HPHUJHQF\ VLWXDWL
Phantom 4 Pro/Pro+ User Manual Flight Test Takeoff/Landing Procedures 1MBDF UIF BJSDSBGU JO BO PQFO nBU BSFB XJUI UIF CBUUFSZ MFWFM JOEJDBUPST GBDJOH UPXBSET ZPV 2. Turn on the remote controller and your mobile device, then turn on the Intelligent Flight Battery. 3. Launch the DJI GO app and enter the Camera page. 4. Wait until the Aircraft Indicators blink green. This means the Home Point is recorded and it is now safe UP nZ *G UIFZ nBTI ZFMMPX UIF )PNF 1PJOU IBT OPU CFFO SFDPSEFE 5.
Appendix © 2016 DJI. All Rights Reserved.
Appendix 6SHFLÀFDWLRQV Aircraft Weight (Battery & Propellers Included) 1380 g Diagonal Size (Excluding Propellers) 350 mm Max Ascent Speed Sport mode: 19.7ft/s(6 m/s); GPS mode: 16.4ft/s(5 m/s) Max Descent Speed Sport mode: 13.1ft/s(4 m/s); GPS mode: 9.8ft/s (3 m/s) Max Speed 44.7mph (20 m/s); 35.8mph (16 m/s) (Attitude mode); 31.
Phantom 4 Pro/Pro+ User Manual Camera Sensor 1’’ CMOS; Effective pixels: 20 M FOV ( Field Of View ) 84° 24 mm ( 35 mm format equivalent ) Lens ISO Range G G BVUP GPDVT BU N ñ Video: 100 – 3200 (Auto); 100 - 6400 (Manual) Photo:100 - 3200 (Auto);100 - 12800(Manual) Mechanical Shutter 8 - 1/2000 s Electronic Shutter Speed 8 - 1/8000 s 3:2 Aspect Ratio: 5472×3648 Max Image Size 4:3 Aspect Ratio: 4864×3648 16:9 Aspect Ratio: 5472×3078 16:9 Aspect Ratio: 5248×2952 (3840×2160 24/25/30p, 27
Phantom 4 Pro/Pro+ User Manual Max. Bitrate Of Video Storage 100 Mbps Supported File Systems '"5 õ (# FY'"5 (# Photo JPEG, DNG (RAW), J+R Video MP4/MOV (AVC/H.264; HEVC/H.265) Supported SD Cards Micro SD, Max capacity: 128GB. Class 10 or UHS-1 rating required Operating Temperature Range 32° to 104° F (0° to 40° C) Remote Controller Operating Frequency Max Transmission Distance 2.400 - 2.483 GHz, 5.15-5.25GHz and 5.725 - 5.850 GHz FCC Compliant: 3.1 mi (5 km); CE Compliant: 2.
Phantom 4 Pro/Pro+ User Manual Warning Fast Yellow Flashing Remote Controller Signal Lost Slow Red Flashing Low Battery Warning Fast Red Flashing Critical Battery Warning Red Flashing Alternatively IMU Error — Solid Red Critical Error Red and Yellow Flash Alternatively Compass Calibration Required Firmwares Update 5IF mSNXBSF VQEBUF XJMM UBLF BSPVOE NJOVUFT *U JT OPSNBM UIBU UIF HJNCBM HP MJNQ BJSDSBGU status indicator blinks abnormally and the aircraft reboots.
Phantom 4 Pro/Pro+ User Manual Follow Me A virtual tether is created between the aircraft and the mobile device so that the aircraft can track your movement as you move. Note that Follow Me performance is subject to the GPS accuracy on the mobile device. 3FDPSE B nJHIU QBUI UIFO UIF BJSDSBGU XJMM nZ BMPOH UIF TBNF QBUI SFQFBUFEMZ XIJMF Waypoints ZPV DPOUSPM UIF DBNFSB BOE PSJFOUBUJPO 5IF nJHIU QBUI DBO CF TBWFE BOE SF BQQMZ JO the future.
Phantom 4 Pro/Pro+ User Manual a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver.
DJI Support http://www.dji.com/support Appendix This content is subject to change. Download the latest version from KWWS ZZZ GML FRP SURGXFW SKDQWRP If you have any questions about this document, please contact DJI by sending a message to 'RF6XSSRUW#GML FRP. PHANTOMTM is a trademark of DJI. Copyright © 2016 DJI All Rights Reserved.