User's Manual

Ronin-M
User Manual
©
2015 DJI. All Rights Reserved.
31
Remote Control Features
MODE: The MODE switch is used for toggling SmoothTrack.
1. In Position 1, Smooth Track is off. Remote control is freely position pan
axis stops and holds the last input position of the pan axis control stick.
2. In Position 2, Smooth Track is on. Remote control is freely position pan
axis stops and holds the last input position of the pan axis control stick.
3. In Position 3, Smooth Track is on. The gimbal will always point and reset
pan to the forward facing direction once the pan axis control stick is let go.
Position 1
-Free, SmoothTrack Off
Position 2
-Free, SmoothTrack On
Position3
-Reset to Center, SmoothTrack On
FUNCTION: 1. The FUNCTION switch is used to select the SmoothTrack speed.
There are 3 possible selections: Fast, Normal and Slow. The value
of each speed can be preset in the App or PC Assistant.
Position 1
-Fast Position 2 -Normal Position3 -Slow
2. Activating Motor Kill Switch
Quickly ip the FUNCTION Switch between Position 1 and Position
3 consecutively for 3 times and you will activate the motor kill
switch. Do the same again to turn off the motor kill switch. Prior to re-
activating the gimbal motors, be sure to position the camera in the
standard operating position. The motor kill switch is useful in case
the gimbal operator runs into an issue or you need to make a quick
mechanical adjustment to the gimbal or camera setup.
Left Stick: Horizontal movements on the left stick control the Roll axis. Vertical
movements have no denition.
Right Stick: Horizontal
movements on the right stick
control the Pan axis.
Right Stick:Vertical movements
on the right stick control the Tilt
axis.
These stick settings can be customized in the DJI Ronin-M Assistant App or PC Assistant.
Adding3rdpartytransmitter/receiver
Ronin-M supports 3rd party transmitters/receivers, such as D-Bus or PPM. Connect the transmitter
through the port (refer to Page 8 for the location of D-Bus/PPM port).