User's Manual

Ronin-M

User Manual

Handle Bar Adjustment

The customizable handle bar of the Ronin-M can be removed by following the steps below, if required.

1. Loosen the two screws as shown.

2. Remove the grip from the handle bar.

3. The resulting setup is shown below.

Balancing

To achieve the best performance from the Ronin-M, proper balancing is necessary and a must.

Accurate balance is critical in shots where the Ronin-M will be subjected to extreme movements or

accelerations (running, horseback riding, biking, car mounts, helicopters, etc.) Proper balance will also

offer a longer battery runtime. There are 3 axes that need to be accurately balanced prior to powering

the Ronin-M on and setting up the software.

The camera needs to be fully setup with all accessories prior to installing and balancing

the camera on the gimbal. If you are balancing the camera with a lens cap on, be sure to

remove the lens cap prior to balancing. Be sure whenever balancing the camera that the

Ronin-M’s power is turned off.

PAGE 1
Ronin-M User Manual Handle Bar Adjustment The customizable handle bar of the Ronin-M can be removed by following the steps below, if required. 1. Loosen the two screws as shown. 2. Remove the grip from the handle bar. 3. The resulting setup is shown below. Balancing To achieve the best performance from the Ronin-M, proper balancing is necessary and a must.
PAGE 2
Ronin-M User Manual Step 1: Balancing the Vertical Tilt To adjust the vertical balance, you will need to change the camera’s vertical position. Adjust the height of the crossbar to achieve vertical tilt balance. 1. Rotate the Tilt Axis so that the camera lens is pointing skyward as much as your lens setup will allow and loosen the two vertical adjustment tabs. Gently slide the camera mount crossbar forward or backward until the camera remains pointing skyward when released. 2.