Quick Start Guide

bubbles, proceed with calibration.

① Fill the spray tank with about 10 L of water.

② Loosen all the manual relief valves and press the Spray button on the remote controller until the bubbles in the hoses

have been fully discharged. * Tighten the valves and press the Spray button to stop spraying.

* If the bubbles have still not been fully discharged after an extended period, rotate and remove the valve cover. Reattach

the cover once the bubbles have been fully discharged.

B. Spraying System Calibration

① Make sure that there is more than 6 L of water in the spray tank. In the DJI MG app, tap Execute Operation to enter

Operation View, tap > , then select the correct nozzle model (the standard nozzle is model XR11001VS).

② Tap Calibrate. Select the pump requiring calibration (all of the four pumps are selected by default), and tap Calibration.

③ Calibration will start automatically. After several minutes, the calibration result will be displayed in the app.

● If the app displays a successful calibration, users can proceed with the operation.

● If calibration fails, tap “?” to view the problem and resolve it. Afterwards, select the pump that failed to re-calibrate.

Calibrating the Compass

When the app prompts that compass calibration is required, tap > , slide to the bottom, and select

Advanced Settings > Sensors. Tap Calibration in the compass calibration section, then follow the on-screen instructions.

5. Flight

In the DJI MG app, go to Operation View. Make sure that there is a strong GNSS signal, and the system status bar indicates

Manual Route (GNSS) or Manual Route (RTK). * Otherwise, the aircraft cannot take off.

It is recommended to create a plan for a field and select an operation to enable the aircraft to take off and perform the

operation automatically. Refer to Starting Operations for more information. In other cases, take off and land manually.

* RTK positioning is recommended. In the DJI MG app, go to Operation View > > RTK to enable Aircraft RTK and

select a method for receiving RTK signals.

Takeoff

Perform a Combination Stick Command (CSC) and lowly push the throttle stick up to take off.

Throttle Stick

(left stick in Mode 2)