Quick Start Guide

Landing
To land, pull down on the throttle stick to descend until the aircraft touches the ground. There are two methods to stop
the motors.
Method 1: When the aircraft has landed, push and hold the throttle stick down. The motors will stop after 3 seconds.
Throttle Stick
Method 2: When the aircraft has landed, push the throttle stick down, then perform the same CSC that was used to start
the motors. Release both sticks once the motors have stopped.
Method 1 Method 2
● Spinning propellers can be dangerous. Stay away from spinning propellers and motors. DO NOT start the motors in
confined spaces or when there are people nearby.
● Always keep your hands on the remote controller when the motors are spinning.
● DO NOT stop the motors mid-flight unless in an emergency situation where doing so will reduce the risk of damage or
injury.
● Method 1 is the recommended method for stopping the motors. When using Method 2 to stop the motors, the aircraft
may roll over if it is not completely on the ground. Use Method 2 with caution.
● After landing, power off the aircraft before turning off the remote controller.
Starting Operations
The remote controller is equipped with a screen with a built-in Android system that can run the DJI MG app. The
Intelligent Operation Planning system built into the app can be used to measure the operation area, identify obstacles,
configure waypoints, set aircraft settings, and produce flight route plans. Once flight routes have been planned, they can
be used to command the aircraft to fly routes automatically.
In scenarios with complicated terrain, users can use the Phantom 4 RTK and DJI Terra to plan 3D flight routes, and then
import the routes to the DJI MG app for operation. Refer to the user manual for more information.
Planning Field
DJI MG app supports flight route planning by walking to waypoints, obstacles, and calibration points carrying the remote
controller or an RTK handheld mapping device, or by flying the aircraft to these points. The following description takes
planning by flying the aircraft to these points as an example.
OR