Phantom 3 4K User Manual Battery Level Indicators While Charging LED1 LED2 LED3 LED4 Battery Level 0%~25% 25%~50% 50%~75% 75%~100% Fully Charged Aircraft Battery Protection LED Display The table below shows battery protection mechanisms and corresponding LED patterns.
Remote Controller This section describes the features of the remote controller and includes instructions for controlling the aircraft and the camera. 22 © 2015 DJI. All Rights Reserved.
Remote Controller Remote Controller Profile The Phantom 3 4K remote controller is a multi-function wireless communication device that integrates the video downlink system and aircraft remote control system. The video downlink and aircraft remote control system operate at 2.4 GHz. The remote controller features a number of camera control functions, such as taking and previewing photos and videos, as well as controlling gimbal motion. The remote controller is powered by a 2S rechargeable battery.
Phantom 3 4K User Manual Power Outlet Charger Power Button Controlling the Camera Remote Controller Shoot videos/pictures, view recorded images, and adjust camera settings via the Shutter Button, Camera Settings Dial, Playback Button, and Video Recording Button on the remote controller. [5] [4] [1] [2] [3] [1] Camera Settings Dial Turn the dial to adjust camera settings such as ISO, shutter speed, and aperture without letting go of the remote controller.
Phantom 3 4K User Manual Stick Neutral/Mid-Point: Control sticks are in the center position. Moving the Control Stick: The control stick is pushed away from the center position. Remote Controller (Mode 2) ( Aircraft Indicates Nose Direction) Remarks Moving the left stick to the left or right controls the rudder and rotation of the aircraft. Push the sick left to rotate the aircraft counterclockwise, push the stick right to rotate the aircraft clockwise.
Phantom 3 4K User Manual Adjusting Controller Sticks Hold and twist the controller sticks clockwise or counter clockwise to adjust the length of the controller sticks. A proper length of controller sticks can improve the controlling accuracy. Flight Mode Switch Toggle the switch to select the desired flight mode. You may choose between; P-mode, F-mode and Amode.
Phantom 3 4K User Manual Connecting Your Mobile Device Used to boost the transmission range between the on-board camera and the remote controller, the 2.4 GHz WiFi video downlink is integrated into the remote controller and provides the device with an effective communication range of up to 0.62 miles (1000 m). It also enables the remote controller to connect to the DJI GO app wirelessly. Connecting to the WiFi Video Downlink: 1. Switch on the remote controller. 2. Turn on the aircraft. 3.
Phantom 3 4K User Manual Status LED Alarm Remote Controller Status — Solid Red Chime The remote controller is disconnected from the aircraft. — Solid Green Chime The remote controller is connected to the aircraft. Slow Blinking Red D-D-D...... Remote controller error. / Red and Green/ Red and Yellow Alternate Blinks None HD downlink is disrupted. RTH LED Sound Remote Controller Status — Solid White Chime Aircraft is returning home. Remote Controller Blinking White D...
Phantom 3 4K User Manual 4. The remote controller is ready to link. The Remote Controller Status Indicator blinks blue and a beep is emitted. RC Control Setting RC Calibration Stick Mode Searching for aircraft frequency, timeout in 54 seconds Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled. Do not change unless familiar with your new mode.
Camera and Gimbal This section provides the technical specifications of the camera and explains the gimbal’s operation modes. 30 © 2015 DJI. All Rights Reserved.
Camera and Gimbal Camera Profile The on-board camera uses the 1/2.3 inch CMOS sensor to capture video (up to 4096x2160p at 24fps or 4K at up to 30fps with the Phantom 3 4K) and 12 megapixel stills. You may choose to record the video in either MOV or MP4 format. Available picture shooting modes include burst, continuous, and time-lapse mode. A live preview of what the camera sees can be monitored on the connected mobile device via the DJI GO app.
Phantom 3 4K User Manual Camera Operation Use the Shutter and Video Recording buttons on the remote controller to shoot the images or videos through the DJI GO app. For more information about how to use these buttons, refer to “Controlling the Camera Page 24”. Camera LED Indicator Camera LED Indicator lights up after the flight battery is powered on. It provides information on the working status of the camera. Camera LED Indicator Camera status Gimbal Camera Green Fast Blink (0.2s off, 0.
Phantom 3 4K User Manual Gimbal Operation Modes Two gimbal operation modes are available. Switch between the different operation modes on the camera settings page of the DJI GO app. Note that your mobile device must be connected to the remote controller for changes to take effect. Refer to the table below for details: Follow Mode The angle between gimbal’s orientation and aircraft’s nose remains constant at all times.
DJI GO app This section introduces the four main functions of the DJI GO app. 34 © 2015 DJI. All Rights Reserved.
DJI GO app The DJI GO app is a mobile application designed specifically for the Phantom 3 4K. Use this app to control the gimbal, camera, and other aircraft functions. The app also features Map, Academy, and User Center, which are used for configuring your aircraft and sharing your photos and videos with others. It is recommended that you use a tablet for the best experience.
Phantom 3 4K User Manual [1] Flight Mode : The text next to this icon indicates the current flight mode. Tap to configure the MC (Main Controller) Settings. These settings allow you to modify flight limits and set the gain values. The aircraft is set to “Beginner Mode” by default. The aircraft cannot fly 30 meters (98 feet) higher and beyond the recorded Home Point under beginner mode. Disable this mode in the MODE setting page. [2] GPS Signal Strength : This icon shows the current strength of GPS signals.
Phantom 3 4K User Manual Shutter : Tap this button to take a single photo. Press and hold this button to select single shot, triple shot or time-lapsed shooting modes. Record : Tap once to start recording video, then tap again to stop recording. You can also press the Video Recording Button on the remote controller, which has the same functionality. Playback : Tap to enter the playback page. You can preview photos and videos as soon as they are captured.
Phantom 3 4K User Manual [16] Auto Takeoff/Landing / : Tap to initiate auto takeoff or landing. [17] Livestream : Livestream icon indicates the current video feed is broadcasting live on YouTube. Be sure the mobile data service is available on the mobile device. [18] Back : Tap to return to the main GUI. Director DJI Pilot App Director is an automatic video editor built into the DJI GO app. After recording several video clips, simply tap “Director” from the app’s home screen.
Flight This section describes safe flight practices and flight restrictions. © 2015 DJI. All Rights Reserved.
Flight Once pre-flight preparation is complete, it is recommended that you use the flight simulator in the DJI GO app to hone your flight skills and practice flying safely. Ensure that all flights are carried out in an open area. Flight Environment Requirements Flight 1. Do not use the aircraft in severe weather conditions. These include wind speeds exceeding 10 m/s , snow, rain and fog. 2. Only fly in open areas.
Phantom 3 4K User Manual GPS Signal Strong Blinking Green Flight Limits DJI GO app Aircraft Status Indicator Maximum Flight Altitude Aircraft's altitude cannot exceed the specified value. Warning: Height limit reached. None. Max Radius Flight distance must be within the max radius. Warning: Distance limit reached. Rapid red flashing when close to the max radius limit.
Phantom 3 4K User Manual 1640 feet 66 feet 1 mile R1 R2 320 feet 1640 feet 66 feet 1 mile 320 feet R1 R2 Restricted Area Flight (1) Restricted Areas does not have flight altitude restrictions. (2) R miles around the designated restriction area is a Take-off Restricted area. Aircraft cannot take off within this zone. The value of R varies based on the definition of the restricted areas. (3) A “warning zone” has been set around the Restricted Area. When the aircraft approaches within 0.
Phantom 3 4K User Manual GPS Signal Strong Zone No-fly Zone Warning zone Free zone Aircraft Status Indicator Restriction DJI GO app Prompt Motors will not start. Warning: You are in a No-fly zone. Take off prohibited. If the aircraft enters the restricted area in A-mode, but is switched to P-mode, the aircraft will automatically descend, land, and stop its motors. Warning: You are in a no-fly zone. Automatic landing has begun.
Phantom 3 4K User Manual Preflight Checklist 1. 2. 3. 4. 5. 6. Remote controller, Intelligent Flight Battery, and mobile device are fully charged. Propellers are mounted correctly and firmly. Micro-SD card has been inserted, if necessary. Gimbal is functioning normally. Motors can start and are functioning normally. The DJI GO app is successfully connected to the aircraft. Calibrating the Compass IMPORTANT: Always calibrate the compass in every new flight location.
Phantom 3 4K User Manual 3. Hold the aircraft vertically, with nose pointing downward, and rotate it 360 degrees around the center axis. Recalibrate the compass if the Aircraft Status Indicator glows solid red. Flight If the Aircraft Status Indicator blinks red and yellow after the calibration procedure, move your aircraft to a different location and try again. Calibrate the compass before each flight. Launch the DJI GO app and follow the on-screen instructions to calibrate the compass.
Phantom 3 4K User Manual Auto-Landing Use auto-landing only if the Aircraft Status Indicators are blinking green. Follow the steps below to use the auto-landing feature: 1. Ensure the aircraft is in P- mode. 2. Check the landing area condition before tapping “ instructions. ”, to begin landing. Then follow the on-screen Starting/Stopping the Motors Starting the Motors A Combination Stick Command (CSC) is used to start the motors. Push both sticks to the bottom inner or outer corners to start the motors.
Phantom 3 4K User Manual When the Aircraft Status Indicators blink yellow rapidly during flight, the aircraft has entered Failsafe mode. A low battery level warning is indicated by the Aircraft Status Indicators blinking red slowly or rapidly during flight. Watch our video tutorials for more flight information. Video Suggestions and Tips 1. Go through the full pre-flight checklist before each flight. 2. Select the desired gimbal operation mode in the DJI GO app. 3. Only shoot video when flying in P-mode.
FAQ 48 © 2015 DJI. All Rights Reserved.
Troubleshooting (FAQ) Can I remove the camera and attach my own? No. The cameras that come with both models are permanently attached. Attempting to remove, replace, or modify the camera may damage the product and will void your warranty. Can I charge my Remote Controller and Intelligent Flight Battery at the same time? While the Remote Controller charger and Intelligent Flight Battery charger have been integrated into one unit for your convenience, it is recommended that you only charge one item at a time.
Phantom 3 4K User Manual movement of the aircraft and the left control stick controls the throttle and orientation of the aircraft. These controls can be changed to Mode 1 or set to a customized configuration in the DJI GO app. This is only recommended for advanced users. Can I use a Phantom 2 Intelligent Flight Battery with the Phantom 3? No. The Phantom 3 uses a newly designed Intelligent Flight Battery with greater power. The Phantom 3 has a 4 cell battery with a capacity of 4480 mAh and a voltage of 15.
Phantom 3 4K User Manual Do not remove the Micro-SD card from the camera. If it has been removed, place it back in the camera. Turn the Phantom 3 on and wait approximately 30 seconds as the video file is restored. How can I ensure that my pictures and videos will be synchronized to my iOS album? You may need to adjust the settings of your mobile device. Open the Settings menu, select the Privacy tab, select the Photos tab, and then toggle the switch next to the DJI GO app icon.
Phantom 3 4K User Manual Various factors contribute to the aircraft initialization error, try resolve the issue by following the suggestions listed below: • Sensor performance degraded. This may be due to the excessive bias detected from the IMU or the compass reading is interfered. Try restarting and calibrating the IMU and compass to resolve this issue. • Sensor is defective.
Appendix © 2015 DJI. All Rights Reserved.
Appendix Specifications Aircraft Model Weight (Battery & Propellers Included) Phantom3 4K 1280 g Max. Ascent Speed 5 m/s Max. Descent Speed 3 m/s Max. Speed 16 m/s (ATTI mode, no wind) Max Service Ceiling Above Sea Level 6000 m (Software altitude limit: 120 m above takeoff point) Max.
Phantom 3 4K User Manual WiFi Operating Frequency Max Transmission Distance Transmitter Power (EIRP) 2.400 GHz - 2.483 GHz FCC: 1000 m; CE: 500 m (outdoors and unobstructed, aircraft’s altitude at 400 feet/120 m) FCC: 27 dBm; CE: 20 dBm Remote Controller Model GL358wB Operating Frequency 5.725 GHz - 5.825 GHz, 922.7 MHz - 927.
Phantom 3 4K User Manual Warning Fast Yellow Flashing Remote Controller Signal Lost Slow Red Flashing Low Battery Warning Fast Red Flashing Critical Battery Warning Red Flashing Alternatively IMU Error — Solid Red Critical Error Red and Yellow Flash Alternatively Compass Calibration Required Firmwares Update Use Micro SD card to update the aircraft and Intelligent Flight Battery. Connect to the Internet, launch the DJI GO app.
Phantom 3 4K User Manual FCC Warning Message Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Phantom 3 4K User Manual Cet appareil est conforme aux limites d'exposition de rayonnement RF IC établies pour un environnement non controlé. Cet émetteur ne doit pas être co-implanté ou fonctionner en conjonction avec toute autre antenne ou transmetteur. Cet équipement doit être installé et utilisé avec une distance minimale de 20cm entre le radiateur & votre corps.
This content is subject to change. Download the latest version from http://www.dji.com/product/phantom-3 If you have any questions about this document, please contact DJI by sending a message to DocSupport@dji.com. © 2015 DJI. All Rights Reserved.