User's Manual

12
OPERATING THE PROJECTOR
seTup
1. Install included (2) AAA batteries in the remote control.
• Turn the remote control over and locate the battery door on the rear of the unit.
• Press on the remote door arrow and slide in the direction indicated by the arrow.
• Insert batteries as pictured on the inside of the battery compartment.
IMPORTANT: Insert batteries negative (-) side first into the slots , pushing it into the coil
and then into the compartment. Do not insert batteries positive (+) side first.
• Place battery door over compartment, lining up the door tab with the opening on the
remote. Slide the door until it securely snaps into place.
2. The projector can be powered using the internal battery or while plugged into power
with the USB 2.0 Type C charging cable.
• To power the projector with AC power, connect the power adapter to the USB
2.0 Type C charging cable. Connect the USB 2.0 Type C end of the cable to the