User manual

55
Problem: The tuner works normally, but
only picks up a very small
number of stations or none at
all.
Cause:
The aerial system or the aerial
cable itself is defective.
Remedy1:
Check the aerial lead for good
contact at the aerial wall socket
and at the tuner.
Remedy2:
Check the aerial cable for dam-
age and sharp bends (kinks). If
necessary, replace it with a new
cable.
Problem: After a house-move the screen
continues to show a few of the
old station names - but those
stations cannot be picked up.
Cause:
The unit is still storing some
pre-sets with station names and
reception frequencies which
cannot be received at the new
location.
Remedy1:
Erase the non-receivable pre-
sets individually - see Tuner
special functions: ‘ERASE
PRESETS’.
Remedy2: Erase all stored presets.
• To do this switch on the unit
and hold the 

 button
pressed in until a moving
message appears on the
screen.
• Wait until the moving messa-
ge stops, then immediately
press the 

 button on
the remote control handset
and hold it in for about two
seconds. The screen will now
show the message:
'PRES-CLR'.
This erases all the stored pre-
sets.