Data Sheet

Safety data sheet according to 1907/2006/EG, Artikel 31
Trade name:
Acoustic Adhesive 310 ml
Printing date: 2020-02-06 Page 3 of 7
Manufacturer/Supplier:
BOSIG GmbH, Brunnenstraße 75-77, 73333 Gingen-Fils
7.2 Conditions for safe storage, including any incompatibilities:
Storage:
Requirements to be met by storerooms and receptacles:
Store in a cool location.
Store only in the original receptacle.
Information about storage in one common storage facility:
Not required.
Further information about storage conditions:
Protect from frost.
Keep container tightly sealed.
Protect from heat and direct sunlight.
7.3 Specific end use(s):
No further relevant information available.
*8. Exposure controls / personal protection
Additional information about design of technical facilities:
No further data, see item 7.
8.1 Control parameters:
Ingredients with limit values that require monitoring at the workplace:
The product does not contain any relevant quantities of materials with critical values that have to be monitored at the
workplace.
8.2 Exposure controls:
Personal protective equipment:
General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals.
Wash hands before breaks and at the end of work.
Avoid contact with the eyes and skin.
Keep away from foodstuffs, beverages and feed.
Respiratory protection:
Not necessary if room is well-ventilated.
Protection of hands:
Protective gloves.
EN 374
The glove material has to be impermeable and resistant to the product / the substance / the preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation.
Material of gloves:
Polyethylene gloves.
Recommended thickness of the material: ≥ 0.02 mm.
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and
varies from manufacturer to manufacturer. As th e product is a preparation of several substances, the resistance of the
glove material can not be calculated in advance and has therefore to be checked prior to the application.
Penetration time of glove material:
The exact break trough time has to be found out by the manufacturer of the protective gloves and has to be observed.