Mounting Instruction

ManualsBrandst.akustik ManualsAcoustic TreatmentOctagon Shaped Sound Absorber System

ABSORBER RECTAGON

These instructions are for the following products: Rectagon

The following tools are needed for installation of the ab-

sorber:

✓ Cutter ✓ Drilling machine ✓ Screwdriver

✓ Hammer ✓ Drill attachments

TOOLS

Open the package carefully! Inserting sharp objects

into the package can damage the absorber. Avoid

using long, sharp tools for opening the package!

UNBOXING

Carefully remove the products from the package and

read the mounting instructions carefully. Remove the

four-piece mounting ring, the mounting accessories and

the foam plates.

REMOVE PRODUCTS

FROM PACKAGING

MOUNTING INSTRUCTIONS

The following mounting accessories are included for

installation of the absorber:

✓ 1 × four-piece mounting ring ✓ 2 × hinge

✓ 6 × dowel ✓ 12 × screw M4×10

✓ 6 × screw M4×40 ✓ 16 × screw hook

✓ 8 × foam plate ✓ 16 × screw-in eyelet

✓ 16 × adjustable wire rope

MOUNTING ACCESSORIES

Prior to installation, it is imperative to check the load capacity and the condition of the wall.

TIP:

Summary of content (4 pages)

PAGE 1
EN MOUNTING INSTRUCTIONS ABSORBER RECTAGON These instructions are for the following products: Rectagon TIP: Prior to installation, it is imperative to check the load capacity and the condition of the wall.
PAGE 2
ASSEMBLING MOUNTING RING Assemble first two parts of the mounting ring using the foldable hinge and six screws M4×10. Assemble in the same way the other two parts of the mounting ring. DETERMINE POSITION Place the assembled two-piece mounting ring to the required position and mark the two drilling holes of the first part of the mounting ring. Drill the holes.
PAGE 3
FIX WIRE ROPES TO MOUNTING RING Insert the eyelets of the adjustable wire ropes into the screw hooks. FIX FOAM PLATES TO WIRE ROPES Insert the hooks of the adjustable wire ropes into the screw-in eyelets of the foam plates. ADJUSTING HEIGHT Adjust the height of the foam plates as you wish. Fix the excess wire rope using cable straps. ASSEMBLE FOAM PLATES Press the individual foam plates against one another for assembling them with the integrated magnets. USING ABSORBER Now you can use the absorber.
PAGE 4
Find more solutions for your room on our website: www.takustik.com Share your installation with us on Instagram: www.takustik.com/instagram This product is intended to be used to optimise the room acoustics. Any other use or use under other operating conditions is considered to be improper and may result in personal injury or property damage. No liability will be assumed for damages resulting from improper use. Ensure that plastic bags, packaging, etc.