Installation

ManualsBrandsT and S Brass ManualsShop AllT and S Brass Double Pedal Valve with Loose Key Angle Stop and Straight Volume Control

Limited One Year Warranty

T&S warrants to the original purchaser (other

than for purposes of resale) that such product

is free from defects in material and workman-

ship for a period of one (1) year from the date

of purchase. During this one-year warranty pe-

riod, if the product is found to be defective, T&S

shall, at its options, repair and/or replace it. To

obtain warranty service, products must be re-

turned to…

T&S Brass and Bronze Works, Inc.

Attn: Warranty Repair Department

2 Saddleback Cove

Travelers Rest, SC 29690

Shipping, freight, insurance, and other trans-

portation charges of the product to T&S and

the return of repaired or replaced product to the

purchaser are the responsibility of the pur-

chaser. Repair and/or replacement shall be

made within a reasonable time after receipt by

T&S of the returned product. This warranty does

not cover Items which have received second-

ary finishing or have been altered or modified

after purchase, or for defects caused by physi-

cal abuse to or misuse of the product, or ship-

ment of the products.

Any express warranty not provided herein,

and any remedy for Breach of Contract which

might arise, is hereby excluded and disclaimed.

Any implied warranties of merchantability or fit-

ness for a particular purpose are limited to one

year in duration. Under no circumstances shall

T&S be liable for loss of use or any special con-

sequential costs, expenses or damages.

Some states do not allow limitations on how

long and implied warranty lasts or the exclu-

sion or limitation of incidental or consequential

damages, so the above limitations or exclusions

may not apply to you. Specific rights under this

warranty and other rights vary from state to

state.

P/N: 098-003116-45 Rev 3

Date: 11-08-01

Drawn: TEH

Checked: DLT 11-27-01

Approved: MVW 12-11-01

Installation and

Maintenance

Instructions

WALL MOUNTED

FOOT PEDAL VALVE

B-0504 and B-0508

Deutsch: Installations- und

Wartungsanleitungen

Español: la Instalación y las

Instrucciones de

Mantenimiento

Français: les Instructions

d’Installation et

d’Entretien

Summary of content (8 pages)

PAGE 1
Installation and Maintenance Instructions Limited One Year Warranty T&S warrants to the original purchaser (other than for purposes of resale) that such product is free from defects in material and workmanship for a period of one (1) year from the date of purchase. During this one-year warranty period, if the product is found to be defective, T&S shall, at its options, repair and/or replace it. To obtain warranty service, products must be returned to… T&S Brass and Bronze Works, Inc.
PAGE 2
Exploded View * Some items are listed for instructional purposes and may not be sold as separate parts.
PAGE 3
Part Number Guide Double Pedal Valve Assembly 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 Body, Double Pedal Shaft Socket Plug Screw, Mounting Screw, S.S. Pedal Spring Retain Spacer, Pedal Spring Spring, LH Pedal Hot Spring, RH Pedal Cold Pad, Nylon Screw, Nylon Pad Nut, Adjustable Screw Lock Set Screw, Adjustable Snap-Ring, Shaft Bushing Foot Pedal, L.H. Hot Foot Pedal, R.H.
PAGE 4
General Instructions Installation: 1. Shut off water supply and drain lines. 2. Mount no.1 assembly to wall with two no.4’s, no more than 8-7/8” [21 cm] from floor to center of mounting holes. (See illustration.) Note: It is strongly recommended that each supply line be equipped with a hammer arrester installed per manufacturer’s instructions. A typical installation is shown: hammer arrester out in 1 Note: Piping and hammer arrestor supplied by others.
PAGE 5
Instrucciones Generales Instalación: 1. Cierre el surtido de agua y desagüe las tuberias. 2. Monte el ensamble No.1 a la pared con dos partes No.4, a una distancia de no más de 8-7/8” [21 cm] de el piso hasta el centro de los huecos de montadura. (Vea la ilustración) Nota: Es altamente recomendado que cada línea de surtido sea equipada con amortiguador de vibración. Una instalación típica esta demostrada: Amortiguador de vibración Fuera en 1 Nota: Tuberia y amortiguador de vibración surtido por otros.
PAGE 6
Instructions Générales L’Installation: 1. Fermer la réserve de l’eau et égoutter la tuyauterie. 2. Monter l’assemblage Nº.1 au mur avec deux Nº.4’s, pas plus de 21cm du plancher au centre des trous montants. (Voir l’illustration). Noter: On lui recommande vivement que chaque canalisation d’alimentation devrait être équipée d’un “arrête-vibrations”. Une installation typique est montrée. un’“arrête-vibrations” hors de Noter: La tuyauterie et “l’arrête-vibrations” est fourir par les autres.
PAGE 7
Allgemeine Anleitungen Installation: 1. Wasserzulauf absperren und Leitungen entleeren. 2. Garnitur Nr. 1 mit zwei Schrauben Nr. 4 nicht höher als 21 cm vom Fußboden bis zur Mitte der Montagelöcher entfernt anbringen (siehe Abbildung). Achtung: Es empfiehlt sich in jeder Wasserleitung einen Rückschlag Arrettierer einzubauen. Typisch erfolt der Einbau wie abgebildet: Rückschlag Arrettierer Abfluss Anmerkung: Rohre und Rückschlag Arrettierer nicht über unsere Firma erhältlich.
PAGE 8
RELATED T&S BRASS PRODUCT LINE B-0507 SINGLE PEDAL VALVE, FLOOR MOUNTED T&S BRASS AND BRONZE WORKS, INC. A firm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, Travelers Rest, SC 29690 Phone: (864) 834-4102 Fax: (864) 834-3518 E-mail: tsbrass@tsbrass.