Installation

6
screws
shroud
Service
CAUTION: Remove all tension before servicing. Hazards or unsafe practices may
CAUTION: Remove all tension before servicing. Hazards or unsafe practices may
result
result
in minor personal injury, product or property damage.
in minor personal injury, product or property damage.
WARNING: Before performing any service, always disconnect and lock out
WARNING: Before performing any service, always disconnect and lock out
compressed
compressed
air or  uid, and remove all spring tension. Hazards or unsafe
air or  uid, and remove all spring tension. Hazards or unsafe
practices could result in severe personal injury or death.
practices could result in severe personal injury or death.
HOSE REPLACEMENT
• Remove shroud screws and shroud (Fig.4).
• Remove all tension from reel. See “TENSION
ADJUSTMENT.” Pull hose
until ratchet “clicks” several times.
• Remove spray valve using 1/2” wrench.
• Pull hose back through guide and unwind
hose completely.
• Rotate reel through “clicks” until hose
connection is exposed.
• Use 9/16” wrench to remove hose
connection from reel.
• Place new hose connection onto reel (no
sealant needed).
• Feed hose around hub, following direction
of arrow on hub shown (Fig.5).
• Wind until hose will  t through hose guide
about 1 foot long.
• Reattach spray valve. Check for leaks.
• Check tension. Adjust tension as needed in
“TENSION ADJUSTMENT “ section.
• Reattach shroud and screws.
• Mount on oven and reattach plumbing.
Figure 4
Figure 5
RATCHET LOCK REPLACEMENT / REMOVAL
• Remove all tension, see “TENSION ADJUSTMENT.”
• Remove shroud and screw (Fig.4). Loosen top
screw (Fig.6) Use e-clip remover and disengage
e-clip from swivel (Fig.6).
Figure 6
e-clip groove
directional arrow
loosen top
screw
top screw
WARNING: Failure to use proper e-clip remover tool
WARNING: Failure to use proper e-clip remover tool
could result in injury.
could result in injury.
General Instructions