Installation

8
SPRAY VALVE REPLACEMENT
• Ensure water is turned o and pressure released from hose.
• Pull hose out until “clicking” stop during the 1-23 click.
• Holding the hose hex nut, twist the spray valve o hose.
• Remove o-ring from hose hex nut.
• Replace o-ring with new o-ring.
• Turn new spray valve until tight.
• Pull hose until clicking stops, retract hose to rest spray valve against hose guide.
HOSE GUIDE REPLACEMENT (Fig.10)
• Remove shroud and screws.
• With long screwdriver, unscrew both screws on hose guide from the back of the reel.
• Pop-o hose guide.
• Pull out hose until locked.
• Unscrew spray valve.
• Pass old hose guide over hose and o .
• Move new hose guide over hose and set into housing. Remember to line up screw holes.
• Replace screws in back of housing and hose guide. DO NOT OVERTIGHTEN.
• Reinstall the spray valve.
• Mount on oven and reattach plumbing.
hose guide
Figure 10
General Instructions