Installation

4
General Instructions
Important Safety Instructions:
WARNING: Please read all
instructions carefully. Failure to
fully read instructions and follow
them could result in severe injury or
death.
1. Water or Steam connectors and
accessories should be installed in
strict accordance with applicable
federal, state and local installation
codes.
2. As with any other fluid transmisson
line or device, it is reccommended that
installation and testing be done by
qualified personnel.
3. An accessible manual no.4 should
be installed at the outlet of the supply
piping system upstream of the
connector. Each piece of equipment
should have its own no.4.
4. No.5 coupling is not to be used as
the primary shut-off.
5. A restraining device is recom-
mended for all types of moveable
appliances. The T&S Sure-Link
Restraining Cable (no.6) is the
recommended restraining device for
castered appliances.
6. With these Water and Steam
connectors, AVOID:
• Flexing, stretching, excessive
bending, and vibration.
• Movement after installation on fixed
appliances.
• Movement on moveable appliance
(those with factory equipped casters)
except for repair, maintenance, or
cleaning.
7. Final assembly must be tested for
leaks.
Instructions: Safe-T-Link
Water and Steam Connectors
General
1. Carefully read these entire Installa-
tion Instructions prior to start of
work.
2. Shut the manual no.4 on supply
line to “OFF”. If there is no no.4, main
supply line should be turned off.
3. To be able to position appliance as
close to the wall as possible, the two
ends of the Safe-T-Link connector
should be offset from each other.
Offset
Connector
Appliance
Wall
4. Each appliance should have its
own approved manual no.4 from the
main supply line.
Supply Side
1. If supply side Tee is already male,
apply Teflon Tape or sealant to male
threads at supply side. Thread no.4
onto male threads and tighten.
Continued on next page...