Operator's Manual
Table Of Contents
- T-Mobile High-Speed Internet Gateway Operator Manual
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI environmental and CRoHS guidelines
- 3 ANSI safety guidelines
- 4 Product description
- 4.1 Product overview
- 4.2 4G/LTE and 5G radio support
- 4.3 4G and 5G band and antenna support
- 4.4 Subscriber Interfaces
- 4.5 Environment
- 4.6 Physical dimensions
- 4.7 Physical interfaces
- 4.8 Typical connection
- 4.9 Mesh Wi-Fi 6 System with the T-Mobile High-Speed Internet Gateway
- 4.10 Management
- 4.11 QR code information
- 4.12 Power
- 4.13 Additional functional and feature information
- 5 Installation
- 5.1 Unpacking the T-Mobile High-Speed Internet Gateway
- 5.2 Product Warnings
- 5.3 Connecting power
- 5.4 Starting up
- 5.5 Downloading the T-Mobile Broadband App
- 5.6 Checking LCD
- 5.7 Connecting to Wi-Fi
- 5.8 Managing the Wi-Fi network
- 5.9 Connecting Accessories (Optional)
- 5.10 Repositioning the T-Mobile High-Speed Internet Gateway
- 5.11 Connecting devices for Wi-Fi or a mesh network
- 5.12 Connecting Ethernet LANs
- 6 Removing battery and SIM card
- 7 Replacing battery and SIM card
- 8 FCC statements and label instructions
- 9 Configuration
- 10 Glossary
- Customer document and product support
T-Mobile High-Speed Internet Gateway Operator
Manual
ChapterTitleVariable
Issue: DRAFT Nokia 3TG-01275-AAAA-TCZZA 43
The screen on the top of the T-Mobile High-Speed Internet Gateway displays the
T-Mobile logo with three screens appearing with sequential dots. After about 4
seconds, concentric circles appear from the center of the LCD screen outwards. The
booting process is complete when:
• “CONNECTION” appears on the top of the LCD
• up to five bars appears indicating signal strength
• six small dots indicating the screen that appears
If the T-Mobile High-Speed Internet Gateway is to use 4G/LTE or 5G service, the
results of searching for 4G/LTE and 5G signals will be shown through the LCD in a
couple of minutes. Check the LEDs as described in section 5.6 and follow the actions
indicated in the section.
5.4.1 T-Mobile High-Speed Internet Gateway on boarding
is not successful
If after the boot up process, the LCD screen does not show:
• “CONNECTION” appears on the top of the LCD
• up to four bars appears indicating signal strength
• six small dots indicating the screen that appears
Instead “LANGUAGES” appears on the LCD screen with the choice of ENGLISH or
ESPANOL.
Tap to select the preferred language.
The T-Mobile logo and the Wi-Fi symbol appears. Tap to toggle between the
T-Mobile App advertisement and the QR code.
While showing the QR code, use the QR code scanner on your phone to scan the
QR code with your mobile device. When scanned correctly, a check mark appears
on the LCD screen. Wait approximately five seconds.
The booting process is complete when:
• “CONNECTION” appears on the top of the LCD
• up to four bars appears indicating signal strength
Then, the App submit a new Wi-Fi SSID and password screen appears.
Tap the screen.
The name of the Wi-Fi service appears on the LCD screen indicating that it is
READY.
Wait approximately five seconds.