Owners manual

21551 21551

04-08 FORD 04-08 FORD

F-150 TRUCKS F-150 TRUCKS

BILLET INSERT BILLET INSERT

04-08 FORD F-150 - W/HONEYCOMB GRILLES

BILLET INSERT & OVERLAY

(Will not fit 4 Wheel Drive Trucks with bars in factory grille)

Tools Required

: Parts List:

Phillips screwdriver 1 Billet Grille (22 Bars)

5/16” Wrench or Pliers 4 6-32 x 2 Machine Screws

Drill and 1/8” Drill Bit*** 4 6-32 Nylon Lock Nuts

File*** 4 #6 Flat Washers

Dremel or Die Grinder w/ Cut-Off Wheel*** 4 2 Flange Brackets (2000F)

4 #8 x ¾ Phillip Screws***

*** Required for Center Cut-Out Style Only

4 #8 Flat Nuts***

NOTE: Please refer to Page 2 for Cut-Out Style instructions

Read and understand instructions before attempting installation

Step 1.

Open the hood and remove the oval Ford emblem from the grille. Center the billet in the opening over

the honeycomb center.

Step 2.

Note the four tabs welded to the rear of the billet grille. Place a machine screw

in the two top tabs. Center the billet insert over the front of the factory grille.

From behind the grille shell; place a flange bracket and flat washer on each

screw. Now thread a nylon lock nut on each. Repeat this process on the lower

tabs with the remaining hardware. Be sure the billet is centered and tighten all

the fasteners (DO NOT OVER TIGHTEN).

Step 3.

The factory Ford emblem can be re-installed over the billet grille with the use of double-sided

tape.

Thank you for purchasing a T-Rex Billet Grille.

PAGE 1 OF 2

PAGE 1
21551 21551 F-150 TRUCKS BILLET INSERT F-150 TRUCKS BILLET INSERT 04-08 FORD 04-08 FORD 04-08 FORD F-150 - W/HONEYCOMB GRILLES BILLET INSERT & OVERLAY (Will not fit 4 Wheel Drive Trucks with bars in factory grille) Tools Required: Parts List: Phillips screwdriver 5/16” Wrench or Pliers Drill and 1/8” Drill Bit*** File*** Dremel or Die Grinder w/ Cut-Off Wheel*** 1 4 4 4 4 4 4 *** Required for Center Cut-Out Style Only NOTE: Billet Grille (22 Bars) 6-32 x 2 Machine Screws 6-32 Nylon Lock Nuts #6
PAGE 2
1551 21551 F-150 TRUCKS BILLET INSERT F-150 TRUCKS BILLET INSERT 04-06 FORD NOTE: 04-06 FORD Please refer to Page 1 for Bolt-On Overlay Style instructions Read and understand instructions before attempting installation Step 1. Open the hood and remove the grille shell from the vehicle. To prevent scratching, apply masking tape to the face of the grille. Step 2. Use a die grinder to cut the honeycomb center out from the center of the grille shell. File or sand the cuts smooth around the opening.