User Manual

HOW TO TAME YOUR REPTILE 2
The main controls on your Reptile 2 are the ECHO, REPEAT, TIME and LEVEL
knobs, while the TEMPO button and the FLUTTER WIDTH, SPEED & TONE
knobs provide further control.
ECHO determines the mix of direct and delayed signal. Turn it down for a sub-
tler natural effect, and crank it up for doubling or freaky long delay effects.
The REPEAT knob lets you control the number of times a sound is repeated –
from just once to a virtual infinity.
TIME determines the rate of your echo repeats and can be adjusted from 10
ms to 1 sec. TIP: to experiment, try tuning in a classic 50s slap-back sound by
combining a fast time with a low repeat value.
The FLUTTER WIDTH & SPEED controls let you simulate and adjust that
great tape-delay “warbled” effect, while the TONE knob at the top of the
FLUTTER section lets you take the high-end edge off your delay repeats
for a more authentic vintage sound.
The TEMPO button activates your pedal’s TAP TEMPO function. To auto-
matically adjust the tempo (TIME) of your delay to match the tempo of
the song you’re playing, just use your foot to tap the button along with
the beat.
Note: The INPUT LEVEL knob on the side of your Reptile 2 eliminates
overdrive distortion caused by too high an input signal. Keep it set just
below where the red light comes on.