Installation Guide

ManualsBrandsT&S BRASS ManualsKitchenPre-rinse Unit

Limited One Year Warranty

T&S warrants to the original purchaser (other

than for purposes of resale) that such product

is free from defects in material and workman-

ship for a period of one (1) year from the date

of purchase. During this one-year warranty

period, if the product is found to be defective,

T&S shall, at its options, repair and/or replace

it. To obtain warranty service, products must

be returned to…

T&S Brass and Bronze Works, Inc.

Attn: Warranty Repair Department

2 Saddleback Cove

Travelers Rest, SC 29690

Shipping, freight, insurance, and other

transportation charges of the product to T&S

and the return of repaired or replaced product

to the purchaser are the responsibility of the

purchaser. Repair and/or replacement shall be

made within a reasonable time after receipt by

T&S of the returned product. This warranty does

not cover Items which have received secondary

ﬁ nishing or have been altered or modiﬁ ed after

purchase, or for defects caused by physical

abuse to or misuse of the product, or shipment

of the products.

Any express warranty not provided herein,

and any remedy for Breach of Contract which

might arise, is hereby excluded and disclaimed.

Any implied warranties of merchantability or

ﬁ tness for a particular purpose are limited to

one year in duration. Under no circumstances

shall T&S be liable for loss of use or any special

consequential costs, expenses or damages.

Some states do not allow limitations on

how long and implied warranty lasts or the

exclusion or limitation of incidental or conse-

quential damages, so the above limitations or

exclusions may not apply to you. Speciﬁ c rights

under this warranty and other rights vary from

state to state.

P/N: 098-003120-45 Rev.3

Date: 09-11-14

Drawn: TEH

Checked: JRM 09-12-14

Approved: JHB 09-19-14

Installation and

Maintenance

Instructions

PRE-RINSE UNIT

B-2250

(Retroﬁ t for Pre-Rinse Units)

Deutsch: Installations- und

Wartungsanleitungen

Español: la Instalación y las

Instrucciones de

Mantenimiento

Français: les Instructions

d’Installation et

d’Entretien

Summary of content (8 pages)

PAGE 1
Installation and Maintenance Instructions Limited One Year Warranty T&S warrants to the original purchaser (other than for purposes of resale) that such product is free from defects in material and workmanship for a period of one (1) year from the date of purchase. During this one-year warranty period, if the product is found to be defective, T&S shall, at its options, repair and/or replace it. To obtain warranty service, products must be returned to… T&S Brass and Bronze Works, Inc.
PAGE 2
Exploded View 3 2 4 5 1 6 7 * Some items are listed for instructional purposes and may not be sold as separate parts.
PAGE 3
Part Number Guide Pre-Rinse Unit 1 2 3 4 5 6 7 Assembly, Spray Valve Assembly, Flex Stainless Steel Hose Spring, Overhead Spring, Body Nipple, 3/8” x 24” Assembly, Finger Hook & Screw Assembly, Base Faucet ‘B-0111’ 3 B-0107 B-0044-H 000888-45 000821-40 000372-40 004R 002824-40
PAGE 4
General Instructions Installation: See separate instructions for installing no.7 into deck. 4. Adjust position of no.6 so that no.1 hangs loosely in it without straining no.2 or no.3. 1. Shut off water supply and drain lines. Apply teflon tape or pipe joint compound to threads on both ends of no.5. Screw no.5 into no.7 and hand tighten. 2. Slide no.6 down no.5 (about halfway) and tighten temporarily. 3 6 2 5 7 1 3. Screw no.4 down on no.5 and hand tighten, then tighten no.
PAGE 5
Instrucciones Generales Instalación: Nota: Si la parte No.3 nueva se esta instalando en la parte No.2, asegurese que esté instalada al derecho. Mire las instrucciones para la instalación de la parte No.7 dentro del mostrador. 1. Cierre la fuente principal de agua y desagüe las turberîas. Aplique cintas para roscas de tuberîas o compuesta de coyuntura a los dos extremos de la parte No.5. Atornille la parte No.5 dentro de la parte No.7 y aprete con una llave. 3 2. Deslize la parte No.
PAGE 6
Instructions Générales L’Installation De L’Élément Pre-Rinçage: Noter: Si vous installer un N°.3 nouveau sur N°.2, soyez certain de l’installer dans une position verticale. Consulte las instrucciones específicas para la instalación de Nº.7 en la platina. 1. Fermer la réserve de l’eau et égoutter la tuyauterie. Appliquer le ruban en Téflon ou le composé pour les tuyaux a chaque extrémité de N°.5. Visser N°.5 dans N°.7 et resserrer par le main. 3 2. Faire glisser N°.6 à mi-chemin N°.
PAGE 7
Allgemeine Anleitungen Installation: Anmerkung: Falls ein neues Nr. 3 auf Nr. 2 montiert wird, ist sicherstellen, daß Nr. 3 aufrecht installiert wird. Nr. 7 gemäß Anleitungen auf die Abdeckplatte montieren. 1. Wasser absperren und Wasserleitungen entleeren. Teflonband oder Rohrkitt an beiden Seiten des Gewindes von Nr. 5 anbringen. Nr. 5 in Nr. 7 einschrauben und mit Schraubenschlüssel festdrehen. 2. Nr. 6 in Nr. 5 einführen (ungefähr zur Hälfte) und vorübergehend festdrehen. 3 6 2 5 1 7 3. Nr.
PAGE 8
RELATED T&S BRASS PRODUCT LINE B-0100 PRE-RINSE UNIT W/ FLEXIBLE S-STEEL HOSE B-10K PARTS KIT B-0106 PRE-RINSE UNIT W/ BRUSH T&S BRASS AND BRONZE WORKS, INC. A firm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, Travelers Rest, SC 29690 Phone: (864) 834-4102 Fax: (864) 834-3518 E-mail: tsbrass@tsbrass.