Installation Guide

ManualsBrandsT&S ManualsBath2-Handle Faucet with Gooseneck Nozzle in Chrome

P/N: 098-006106-45 Rev.4

Date: 10-05-18

Drawn: TEH

Checked: DMH 12-20-18

Approved: JHB 02-14-19

Español:

Instrucciones de instalación y mantenimiento

Français:

Instructions pour l’installation et la maintenance

Deutsch:

Installations- und Wartungsanleitungen

中文:

安装与维护说明

Installation and

Maintenance

Instructions

Centerset Lavatory

Faucets (with or

without pop-up)

B-0873 & B-0874

Limited One Year Warranty

(Commercial Applications)

T&S warrants to the original purchaser (other

than for purposes of resale) that such product is

free from defects in material and workmanship for

a period of one (1) year from the date of purchase.

During this one-year warranty period, if the product

is found to be defective, T&S shall, at its options,

repair and/or replace it. To obtain warranty service,

products must be returned to...

T&S Brass and Bronze Works, Inc.

Attn: Warranty Repair Department

2 Saddleback Cove

Travelers Rest, SC 29690

Shipping, freight, insurance, and other

transportation charges of the product to T&S and

the return of repaired or replaced product to the

purchaser are the responsibility of the purchaser.

Repair and/or replacement shall be made within a

reasonable time after receipt by T&S of the returned

product. This warranty does not cover Items which

have received secondary ﬁ nishing or have been

altered or modiﬁ ed after purchase, or for defects

caused by physical abuse to or misuse of the

product, or shipment of the products.

Any express warranty not provided herein, and

any remedy for Breach of Contract which might

arise, is hereby excluded and disclaimed. Any

implied warranties of merchantability or ﬁ tness

for a particular purpose are limited to one year in

duration. Under no circumstances shall T&S be

liable for loss of use or any special consequential

costs, expenses or damages.

Some states do not allow limitations on how

long and implied warranty lasts or the exclusion or

limitation of incidental or consequential damages,

so the above limitations or exclusions may not apply

to you. Speciﬁ c rights under this warranty and other

rights vary from state to state.

Attention California Residents:

WARNING This product can expose you to

chemicals including Lead, Chromium (hexavalent

compounds) and Phthalates (DEHP) which are

known to the State of California to cause cancer

and birth defects or other reproductive harm.

For more information go to

www.P65Warnings.ca.gov.

Summary of content (10 pages)

PAGE 1
Installation and Maintenance Instructions Limited One Year Warranty (Commercial Applications) T&S warrants to the original purchaser (other than for purposes of resale) that such product is free from defects in material and workmanship for a period of one (1) year from the date of purchase. During this one-year warranty period, if the product is found to be defective, T&S shall, at its options, repair and/or replace it. To obtain warranty service, products must be returned to...
PAGE 2
Exploded View 14 13 15 18 17 16 12 10 9 8 11 6 7 1 2 3 4 5 2
PAGE 3
Part Number Guide Base Faucet Assemblies 1 2 2 3 4 5 6 8 7 9 8 9 12 10 11 Body, Faucet with Pop-Up B-0873 Body, Faucet without Pop-Up B-0874 Washer, Rosette Locknut Nut, Coupling Asm, Pop-Up Drain Asm, Eterna w/ Spring Checks & Handle (Cold) Asm, Eterna w/ Spring Checks & Handle (Hot) Eterna Cartridge, LTC (Cold) Eterna Cartridge, RTC (Hot) Lever Handle Index, Red - Hot Index, Blue - Cold Screw, Lever Handle Asm, Metering Cartridge w/ Hot Push Button Cap Asm, Metering Cartridge w/ Cold Push Button Cap 12 S
PAGE 4
EN Nozzle Installation: Note: Nozzles should be installed first. 13 1. If converting to a rigid nozzle, place no.12 into faucet body opening before installing nozzle. 12 15 2. Insert no.13 into no.1 and rotate to front of sink. 3. Tighten no.16 firmly with a wrench. For swivel repair or replacement of (o-ring) no.15 and (sleeves) no.14: 4. Insert one no.14 onto no.11. Install no.15 on no.11 and lubricate liberally with provided no.18. Install second no.14 onto no.11.
PAGE 5
L’Installation du Robinet: 5. Fermer la réserve de l’eau et égoutter la tuyauterie. Percer (2) deux trous dans l’évier ou le comptoir . 6. Retirer les Nº. 4, 3 et 2 de l’axe Nº.1, appliquer du mastic de plombier sous la face inférieure du No 1, puis installer à travers les trous de l’évier. Remettre en place les Nº.2, 3 et 4 sur l’axe Nº.1. Serrer le Nº.3 avec une clé. 7. Brancher les tuyaux qui fournir l’eau et vérifier s’il y a des fuites.
PAGE 6
a. o-ring b. pop-up drain stopper m. stem o. drain pipe c. flange n. screw c. flange d. rubber washer e. washer f. locknut g. drain body p. sink base l. lift rod q. flange flush with sink bottom h. ball rod i. gasket d. rubber washer e. washer f. locknut j. nut g. drain body k. rod clip a. Anillo de caucho l’anneau de o O-Ring 型圈 b. Tapón le bouchon instantané e. Arandela la rondelle Unterlegscheibe 垫圈 f. contratuerca le contre-écrou Verschraubung 锁紧螺母 i.
PAGE 7
6. Reinsert rod ball assembly back into drain body and through hole in drain stopper. 7. Insert pop-up stem through hole in faucet body. Attach lift rod to pop-up stem by inserting stem through hole in lift rod. Reassemble rod guide, washer and nut, and tighten firmly. 8. Adjust pop-up stem to correct height by opening, and sliding lift rode and rod clip at the same time onto rod/ball assembly. Readjust lift rod screw if necessary, hand-tighten. 9. Make connection to supply lines. 10.
PAGE 8
Side view faucet and pop-up assembly Dibujo de vista de lado de emsamble de Canilla y tapón la vue du côté du robinet et l’assemblage instantané Seitenansicht von Armatur und Schnellverschluß-Garnitur 侧视龙头和弹出式组件 ES Instalación: (Valvula De Tapón) 1. Remuéva el tapón con el anillo de caucho y el reborde del ensamble del tapón. 2. Remuéva la grampa de varilla, la varilla de gancho, el guia para la tuerca de varilla, la arandela de caucho y el ensamble de la bola con varilla del cuerpo de desagüe. 3.
PAGE 9
7. Insérer le tuyau instantané à travers le trou dans l’égout. Attacher la tige d’ascenseur au tuyau instantané en insérant le tuyau à travers le trou dans la tige d’ascenseur. Réassembler la rondelle et l’écrou qui diriger la tige et resserrer fermement. 8. Régler le tuyau instantané au hauteur correct en ouvrant l’égout, et en mettant la tige d’ascenseur et le collier de la tige, au même temps sur l’assemblage de la tige de boule. Régler la vis de la tige d’ascenseur si nécessaire, resserrer par le main.
PAGE 10
RELATED T&S BRASS PRODUCT LINE B-0870 Centerset Lavatory Faucet with Pop-Up B-0830 Slow Self-Closing Centerset Lavatory Faucet with Pop-Up T&S BRASS AND BRONZE WORKS, INC. A ﬁrm commitment to application-engineered plumbing products 2 Saddleback Cove, P.O. Box 1088, Travelers Rest, SC 29690 Phone: (864) 834-4102 Fax: (864) 834-3518 E-mail: tsbrass@tsbrass.