Mini Hub Quick Installation Guide WLRRTES-102 Mini Hub (Wall plug)
Copyright This DOCUMENT is copyrighted with all rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language in any form by any means without the written permission of Gemtek Technology Co. Ltd. Notice Gemtek reserves the right to change specifications without prior notice. While the information in this document has been compiled with great care, it may not be deemed an assurance of product characteristics.
Buttons Indicators SETUP button, 10 sec press: If in GW Mode: Switch to CONFIG Mode SETUP button, 5 sec press: If in CONFIG Mode: Reboot RESET button, 5 sec press: Factory reset (wipe out WiFi credentials and LNS credentials) LED Indicators Color(s) Blink Pattern Mode Status GREEN blinking 1 sec GW WiFi STA not connected GREEN blinking 1/4 sec GW GREEN Solid GW WiFi STA connected, establishing connection to LNS, configuring radio WiFi STA connected, Sta on connected to LNS, radio liste
Installation Please follow the steps below to install the device: 1. Plug in mini-hub to wall outlet or USB supply. 2. Device will flash green 1 blink per second indicating it is not configured. 3. Press and hold the setup button for 10 seconds until the LED changes to flashing orange. a. This will cause the mini-hub to enter CONGURATION mode and create a wifi-access point with the SSID MiniHub-xxxxxx where the last digits are the last 6 digits of the MAC address. 4.
Troubleshooting Tips If you are experiencing any issues with your device: Restart your device. Restore your device to factory default settings. Contact your service provider or visit the shop. Attention This modem is a complex electronic device. A fall may cause serious damage Never open or try to repair the device by yourself. Repairs should be performed by qualified personal only, otherwise the warranty will be void. Do not expose the device to a very high or very low temperature.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules.
Industry Canada statement: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).