Submittal Sheet
Applications
Stainless
Steel Model
Certified to
NSF/ANSI 61 & 372
Cast Iron Model: Closed loop, pressurized heating and chilled water HVAC systems
Stainless Steel Model: Open loop, potable water systems
The 0034e is a high-performance, variable speed, wet-rotor circulator with
high-eciency ECM permanent magnet technology. With 5 easy settings, its
variable speed performance curves are equivalent to the Taco 009, 0010, 0011,
0012, 0012 3-Speed, 0013, 0013 3-Speed & 0014. Ideal for large residential and
light commercial hydronic heating, chilled water cooling and domestic hot
water systems. The 0034e reduces power consumption by up to 85%
compared to equivalent AC permanent split capacitor circulators.
Specifications
• Maximum Shut-off Head: 34 feet
• Maximum Flow: 50 gpm
• Maximum Operating Pressure: 150 psi
(10.3 bar)
• Maximum Water Temp: 230°F (110°C)
• Minimum Water Temp: 14°F (-10°C)
• Electrical specifications:
Voltage: 115V/208/230, 50/60 Hz
Single phase
Operating Power Range: 10 - 170W
Max. AMP Rating:
1.48 (115V) - 0.70 (230V)
• Equipped with a Cast Iron or
Stainless Steel casing
• Suitable for chilled water systems
• Stainless Steel model suitable for
open loop potable water systems
• Taco circulators are for indoor use only
• Acceptable for use with water or
maximum of 50% water/glycol solution
Electrical Data
Model Volts Hz Ph
Max
Amps
Watts RPM
All
Models
115/208/230 50/60 1 1.48 10 - 170 830 - 4300
Motor
Type
ECM, Permanent Magnet, Electronically Protected
Materials of Construction:
Casing: ...............................Cast Iron or
................................................Stainless Steel
Stator Housing: .............Composite
Control Base: ..................Composite
Control Cover: ...............Composite
Cartridge: .......................... Composite
Impeller: ............................Composite
Shaft: ....................................Ceramic
Rotor: ...................................Neodymium
Bearings: ............................Ceramic
Thrust Bearing: .............. Carbon
O-Ring & Gaskets: ........EPDM
Pump Dimensions & Weights
Model Number
Part Number
Casing
Flange
Type
A B C D F G
Wt.lbs.
[kg]
Inches [mm]
0034e-F2
VM3450-HY1-FC2A00
Cast Iron
R
8.05”
[205]
6.22”
[158]
3.25”
[83]
3.20”
[81]
6.22”
[158]
7.05”
[179]
10.5
[4.8]
0034e-SF2
VM3450-HY1-FS2A00
Stainless Steel
3.20
3.25
6.35
6.22
8.05
7.05
G
F
D
C
B
A
Flow
Flow
Flow
Flow
Rotatable Control Cover to
allow mounting in any orientation
Flange Orientation
Rotated (R)
101-192
ECM High-Efficiency Circulator
Effective: March 10,2020 Supersedes: New
Submittal Data Information
Job: Engineer:
Contractor:
Rep:
ITEM NO. MODEL NO.