Installation Guide

ManualsBrandsTaco ManualsPlumbing ProductTacoGenie 1/25 HP Hot Water Recirculating Pump with Undersink Kit

Pre-Fab Easy Installation

For Models: 006-CT-USK, 008-CT-USK

Installation and Operating Instructions for Existing Homes with Standard Piping

Plant I.D. 001-1024 EFFECTIVE: November 1, 2014

102-140

TacoGenie

is manufactured using the highest quality component parts avail-

able. Patented Integral Flow Checks (IFC) are built into each TacoGenie pump

to prevent cold water from entering the hot water line. State-of-the-art electron-

ics allow the TacoGenie to accurately sense temperature and automatically shut

off the pump to maximize comfort and energy savings. TacoGenie saves energy

and water. You can look forward to over 15 years of life expectancy with a

TacoGenie.

taco-hvac.com

A Taco resource – saving product

Instruction Sheet

Summary of content (6 pages)

PAGE 1
Instruction Sheet 102-140 Pre-Fab Easy Installation For Models: 006-CT-USK, 008-CT-USK Installation and Operating Instructions for Existing Homes with Standard Piping Plant I.D. 001-1024 EFFECTIVE: November 1, 2014 TacoGenieTM is manufactured using the highest quality component parts available. Patented Integral Flow Checks (IFC) are built into each TacoGenie pump to prevent cold water from entering the hot water line.
PAGE 2
Installation shall be in accordance with the manufacturer’s instructions or warranty may be voided. IMPORTANT Operation of the TacoGenie without being plumbed into water lines may damage the pump and void the warranty. WARNING: In the event the retaining screws have been pulled out of the housing, DO NOT replace them. Use of any other screw may short out the stator windings, creating a risk of electrical shock.
PAGE 3
INSTALLATION FOR THE CT-SERIES TACOGENIE MODELS 006-CT-USK AND 008-CTUSK The two custom adapter “T”s are designed to simplify your installation to 1⁄2 inch copper hot and cold supply lines. If you have plumbing other than as shown in these instructions, additional fittings may be required. Consult a plumbing professional. ELECTRICAL SUPPLY A 110V electrical supply outlet is required to power the TacoGenie unit.
PAGE 4
INSTALLING THE TACOGENIE STARTER BUTTON The manual starter button is a unique feature to the TacoGenie. Using the manual start button maximizes energy savings and controls operation only when there is a request for hot water as compared to automatic timer controlled systems. 1. Drill a 5⁄8" hole into the desired location, typically the side or front of a vanity cabinet. 2. Insert the gray wire from the controller through the back side of the hole and connect it to the starter button. 3.
PAGE 5
TROUBLESHOOTING – DIAGNOSING SPECIFIC PROBLEMS PROBLEM 1. The pump does not run when push button is pressed. Green LED does not illuminate. 2. The water is not hot enough. 3. There is hot water at the cold water tap. 4. Water is not hot enough when pump shuts down. 5. There is hot water in the cold water lines only POSSIBLE CAUSE A. No power at electrical outlet B.
PAGE 6
LIMITED WARRANTY STATEMENT Taco, Inc. will repair or replace without charge (at the company’s option) any Taco 00 Series circulator or circulator part which is proven defective under normal use within three (3) years from the date of manufacture. In order to obtain service under this warranty, it is the responsibility of the purchaser to promptly notify the local Taco stocking distributor or Taco in writing and promptly deliver the subject product or part, delivery prepaid, to the stocking distributor.