Manualshelf

Install Instructions

ManualsBrandsTaco Manuals00 Series Cast Iron Circulator Pumps008 Variable Speed Setpoint Cast Iron Circulator with Integral Flow Check, Rotated Flange, 1/25 HP
12345678
7
REPLACING CIRCUIT BOARD
1. Disconnect the electrical supply and all field wiring to the circuit board.
2. Unplug the 3-pin plastic connector that connects the motor to the circuit board.
3. Bend the lip of the capacitor base to ease the removal of the circuit board. Pull the circuit board up and out.
4. Reverse directions to install the new circuit board.
NOTES
REPLACING INTEGRAL FLOW CHECK (IFC) ASSEMBLY (if applicable)
1. Disconnect the electrical supply.
2. Reduce system pressure to 0 psi and allow system to return to room temperature. Isolate the circulator by closing the service valves
or draining the system.
3. Remove the body bolts and swing motor assembly away from the body.
4. Remove IFC, using needle nose pliers.
5. Install replacement IFC by pressing valve into casing until it is firmly seated.
6. Reassemble the circulator using the new gasket and bolts supplied.
7. Follow the “Installation” procedure to start up the circulator.