Install Instructions

INSTRUCTIONS

1. Unplug the D’Mand System power cord.

2. Connect Black, Green and Red leads from Motion Sensor to corre-

sponding Black, Green and White leads from Black 3-wire cord on

D’Mand System Pump (see wiring diagram). Use wire nuts provided

in kit. Use wire nuts or electrical tape to isolate Red and Black wire

leads in Gray Cord if round starter button is not installed.

D’MAND

SYSTEM

Motion Sensor

Installation and Wiring Instructions

102-205

PUMP

POWER

CORD

GRAY

2-WIRE

CORD

RED

BLACK

BLACK 3-WIRE

CORD

BLACK BLACK

GREEN

WHITE

GREEN

RED

MOTION SENSOR

ROUND

STARTER

BUTTON

Plant ID No. 001-3886 Supersedes: December 1, 2008 Effective: January 1, 2011

A Taco resource – saving product

PAGE 1
D’MAND® SYSTEM 102-205 Motion Sensor Installation and Wiring Instructions Plant ID No. 001-3886 Supersedes: December 1, 2008 Effective: January 1, 2011 INSTRUCTIONS 1. Unplug the D’Mand System power cord. 2. Connect Black, Green and Red leads from Motion Sensor to corresponding Black, Green and White leads from Black 3-wire cord on D’Mand System Pump (see wiring diagram). Use wire nuts provided in kit.
PAGE 2
3. Remove electrical box cover and carefully remove electronics control board from terminal strip. 4. Turn control board over and locate voltage dip switches in top left corner of board. (See diagram below.) D'MAND SYSTEM CONTROL BOARD 5v 12v VOLTAGE DIP SWITCHES (Set on 12v for Motion Sensor activation) ΔT ADJUSTMENT (Set on 12 o’clock position for 5˚ ΔT) 5. Slide dip switch connector from pin marked “5v” to pin marked “12v”. (See diagram below.) 6.