Quick Start Guide

[phone]
GETTING TO KNOW YOUR TACTACAM
CHARGING & BATTERY INFORMATION
USING THE CAMERA WHILE CHARGING
Control the Tactacam 5.0, 4.0 with Wi-Fi while the camera is plugged into a USB
charging adapter, including the Tactacam wall charger. (You cannot record while
charging the camera through a computer.) Your Tactacam 5.0, 4.0, 3.0, and Solo can
also capture video when connected to a USB external charging device.
Note: Because the back cap is off, the camera is not water-resistant during charging.
BATTERY STORAGE AND HANDLING
The camera contains sensitive components, including the battery. Avoid exposing your
camera to extreme temperatures. Low or high temperature conditions may temporarily
shorten the battery life or cause the camera to temporarily stop working properly. Avoid
dramatic change in temperature or humidity when using the camera, as condensation
may form on or within the camera.
When storing your Tactacam, charge the battery so it’s 75% or higher. Remove the
battery to eliminate the possibility of internal corrosion. Replace the back cap to protect
against dust and other unwanted substances.
The removable battery in the camera is replaceable if it has failed. See Battery
troubleshooting and other powering issues.
Do not dry the camera or battery with an external heat source such as a microwave,
oven, or hair dryer. Damage to the camera or battery caused by contact with liquid
inside the camera is not covered under the warranty.
Do not make any unauthorized alterations to the camera. Doing so may compromise
safety, regulatory compliance, performance, and will void the warranty.