TTX300 Radio System Manual

2
TRANSMITTER
The transmitter (Tx) requires 4 “AA” batteries.
Non-rechargeable alkaline or rechargeable nickel-
cadmium (NiCd) or nickel-metal hydride (NiMH) cells
can be used. Do not mix old and new cells, or mix
non-rechargeable alkaline cells with rechargeable
NiCd or NiMH cells, etc. See the SERVOS AND
ACCESSORIES section at the end of this manual
for optional rechargeable NiCd and NiMH batteries
and chargers. Note the TTX300 transmitter does
not include a charge jack for rechargeable cells. A
separate “AA” cell charger will be necessary.
IMPORTANT: Do not operate an R/C model with weak batteries as
it could result in reduced range and/or possible loss of control!
Figure 2
Power
LED
On/Off
Power
Switch
Throttle
Reversing
Steering
Reversing
Steering
Rate
Steering
Trim
Throttle
Trim
Channel 3
Buttons
Press the power switch to turn the Tx on (see fi gure 2). The “POWER” LED
should illuminate. If not, turn off the Tx and check the batteries to make sure
each cell is fi rmly in place and in the proper direction. If the Tx LED blinks, the
batteries are low on power and should be replaced.
BIND THE RECEIVER TO THE TRANSMITTER
For proper installation and operation of the 2.4GHz transmitter and receiver
system, it is necessary to “bind” them together electronically. This ensures
sole communication between the two and prevents other transmitters from
being able to control the receiver. To bind the Tx and Rx:
1. Turn on the transmitter.
2. Apply power to the receiver (see the INSTALLATION section that follows
for how to do this).