TTX403 Manual

11
TTX403 4-CHANNEL MICRO SPECIFICATIONS
TTX403 4-Channel Transmitter
Channels 4
Frequencies 2.403 – 2.480GHz
Modulation FHSS spread spectrum
Input power Five “AA” alkaline, NiCd, or NiMH cells (4.0 - 8.0V, not included)
Rated output power < 100 mW
Power indicators Red LED, with 4.5V low battery indicator
Audible tones Low voltage alarm, Trim lever adjustments, Stick mode setting
Servo reversing All channels
Stick modes 3-channel and 4-channel configurations
Battery type and size For external 1S LiPo battery
Charge jack Micro LiPo connector
Output voltage 3.7V nominal, 4.20V maximum
Charge current 250mA
Backup safety timer 45 minutes
Built-in LiPo Charger
Trims Digital for all channels
IMPORTANT WARNINGS AND PRECAUTIONS
● NEVER allow water or moisture to make contact with the electronic
components inside the transmitter, receiver, servos, switch harness,
etc.! This could lead to failure or improper functionality of components
and poor control of aircraft which could pose a safety hazard.
● NEVER operate R/C model aircraft near power lines, radio or cell phone towers,
roads or automobiles, buildings, or pedestrians. Be very careful in locations where
many R/C aircraft are being used simultaneously.
● NEVER operate R/C equipment if you are physically impaired as it could pose a
safety hazard to yourself or others in the area.
● NEVER allow small children to operate/control model R/C equipment without the
supervision of an adult.
● NEVER allow the transmitter’s throttle stick to accidentally be moved away from
the “off” or minimum position while the model’s engine/motor is moving.
● ALWAYS range check the radio system before use.