Manual
18
TRAINER
The process of binding transmitters for training purposes
is explained on page 37. When in training mode with the
TTX650 being used by the teacher, this radio can allow the
teacher to transfer control of all or only certain channels to
the student if desired.
Enter this screen. Press or to select a channel to
set. Press ENTER to toggle the setting. Repeat with other
channels as desired. Setting a channel to SLV means the student will have control of that
channel when the teacher pulls the trainer switch on the master radio. Those channels
which are set to MST will be controlled by the teacher at all times.
The teacher can select which switch will control the training function at the CTRL line at
bottom. The control positions for the trainer switch can also be selected as described on
page 20 (for the Control function). Press ESC to confi rm settings and return to the MODEL
SETUP menu.
TRIM SETTING
The number of degrees a servo will rotate with each increment
of digital trim defl ection can be adjusted, from very small up
to large steps. Enter this screen, select the channel trim to
adjust ranging from “1” for the smallest steps to “20” for the
largest steps.
This menu is for setting servo control functions for airplane
use. Press ENTER briefl y to access this menu.
SERVO SET
Enter this function to adjust any channel’s reversing, sub-trim,
or travel limit setting. The “Reverse” screen will show fi rst. To
move to the “Sub Trim” or “Travel” screen, place the cursor
over “Reverse”, press ENTER and then to fi nd the desired
screen. Press to return to Reverse.
Reverse: Sets the rotational direction
for a channel’s output relative to
the movement of the control stick.
Move the cursor to the channel to
adjust. Set to “NOR” normal or “REV”
reverse. Adjust all reversing settings
before making any other settings or
adjustments in the programming.
TRAINER
CTRL :
SLV
MST
1 2 3 4 5 6
SF
TRIM SETTING
CH1
CH2
CH3
CH4
:
:
:
:
3
3
3
3
AILE
ELEV
THRO
RUDD
SETTINGS MENU – AIRPLANES
SERVO SET
DUAL, EXPO
CH5 AND CH6 SET
THROTTLE CURVE
THROTTLE CUT
SETTINGS
SERVO SET : Reverse
1 NOR
2REV
3 NOR
4REV
5 NOR