Manual

22
Pressing or will adjust the vertical position of curve
at this exact point. Adjust as desired.
Repeat these steps to set points 2, 3,
and 4 on the graph as desired. A point
for “H” is not marked on the graph,
but is the right-most end of the curve
line. The vertical position of this point can be adjusted by moving the cursor to the RATE
percentage. Press ENTER and then or buttons. Press ENTER when fi nished.
To clear any point on the graph, place the cursor on the RATE percent, move the throttle
stick until the graph’s vertical line intersects the point, press ENTER and then CLEAR.
A switch can be assigned to toggle between the linear curve (for starting the engine,
etc.) and the user-defi ned curve (for forward fl ight, stunts, etc.). Select the switch on
the CTRL line.
The exponential control of the user-
defi ned throttle curve (but not the
linear curve) can be active or inhibited.
This will soften or make the transition
of the throttle curve more smooth.
Move the cursor next to the EXPO
line and toggle between “ACT” and
“INH”. Press ENTER when fi nished.
THROTTLE CUT
Allows the throttle channel’s output to be quickly moved to a user-defi ned position by
fl ipping a switch. This is to cease or reduce engine / motor power for safety reasons.
Default setting is 0% (idle).
When setting up the model mechanically, make sure the carburetor is at full-open when
the throttle stick is at full position. Use the trim to adjust the engine idle position. Move
the throttle stick to idle position and turn the assigned throttle hold switch on and off
repeatedly while changing the offset value until the servo stops moving.
Select a switch to control the
throttle cut function on the CTRL
line. Press ESC.
THROTTLE CURVE
Point 1
RATE : +52%
CTRL:-----
EXPO : INH
+15%> +52%
THROTTLE CURVE
Point 4
RATE : +48%
CTRL :SD(0)
EXPO : INH
+81%>+48%
THROTTLE CURVE
Point 4
RATE : +48%
CTRL :SD(0)
EXPO : ACT
+81%>+48%
THROTTLE CUT
:
:
:
:
CTRL
TRIG
CUT .
THRO
-----
+10%
+10%
+10%
TC