Manual

36
Once inside this function, press
ENTER to highlight the “Rate”
value. Press or to fi nd the
desired maximum rate. The circle
graphic represents the maximum
movement rate. Moving the aileron
and/or elevator stick to their limits
will cause the actual position of the
these controls to show at the bottom
of the screen.
PROGRAMMABLE MIXER, RF OUTPUT
AND TIMER
Setting of programmable mixes for helicopters is identical to that for airplanes, as
described on page 27. RF output and timer settings of these functions is identical to that
for airplanes as explained on page 28.
Linking the TTX650 to the Tactic receiver ensures sole communication between the two,
and prevents other transmitters from being able to control the receiver.
1. Turn on the Tx. (Make sure RF Output is set to ON.)
2. Apply power to the Rx.
3. If the Rx LED fl ashes once and then stays on, the Rx is already linked to the Tx
and you can skip to the next section. Otherwise, insert a small diameter screwdriver
through the hole marked “LINK” or “BIND” on the Rx and press the pushbutton until
the Rx LED glows red and then turns off after about one second.
4. Release the “LINK” or “BIND” button.
5. If the linking is successful, the Rx LED will fl ash once and then remain ON.
6. Test for proper Tx/Rx functionality before use. If the radio doesn’t appear to have
become properly linked, repeat steps 1–6 above and move the Tx at least three
feet away from the Rx.
SWASH RING
RATE : 150%
ELEV :
AILE:
0%
0%
SWASH RING
RATE : 88%
ELEV :
AILE:
0%
0%
SWASH RING
RATE : 88%
ELEV :
AILE:
-58%
+65%
LINK THE RECEIVER TO THE TRANSMITTER