Installation & Assembly

STEP 2

Then begin hanging one side of MagnOScreen,

lining up the screen at the center of the door, and ad

hering all Velcro strips starting at the top and working

your way down along the side.

Be sure the center of the Velcro is slightly higher so it can

help in swinging the sides inwards and closing better.

STEP 1

Lay MagnOScreen onto the ﬂoor and attach

Velco

strips onto the screen in the areas shown in

drawing. Before adhering the screen, clean the door

frame with a moist cloth to remove any dust that may

prevent the velcro adhesive from a secure bond.

STEP 3

Continue to hang the other side of MagnO-

Screen, again, lining up the screen at the center of

the door, and adhering all Velcro strips starting at the

top and working your way down along the side.

STEP 4

Finish the installation by using the supplied

tacks to ensure a strong adherance to the frame...and

you’re ready to use your MagnOScreen.

MAGNO SCREEN

Note: If you’re installing on a sliding glass door, measure from the top of the frame to the top of the bottom tract.

If your door opens in, install on the outside of the door. If our door opens out, install on the inside of the door.

To make a MagnOScreen close perfectly, hold the right side of the screen open a second longer than the

left. This will allow the left side to come into position ﬁrst and allow the right side to snap closed against it.

PAGE 1
MAGNO SCREEN Note: If you’re installing on a sliding glass door, measure from the top of the frame to the top of the bottom tract. If your door opens in, install on the outside of the door. If our door opens out, install on the inside of the door. STEP 1 Lay MagnOScreen onto the floor and attach Velco strips onto the screen in the areas shown in drawing. Before adhering the screen, clean the door frame with a moist cloth to remove any dust that may prevent the velcro adhesive from a secure bond.