Operation Manual

Page 4 of 10
2 Radio Compliance
2.1 FCC
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Warning: Any changes or modifications not expressively approved by Taggle Systems could void the user's
authority to operate this equipment.
This equipment is a Limited Certified Transmitter Module. If (1) the module’s FCC ID is not visible when
installed in the host, or (2) if the host is marketed so that end users do not have straightforward commonly used
methods for access to remove the module so that the FCC ID of the module is visible; then an additional
permanent label referring to the enclosed module: “Contains Transmitter Module FCC ID: S7R-BIRDIRRA” or
“Contains FCC ID: S7R-BIRDIRRA” must be used. The host OEM user manual must also contain clear
instructions on how end users can find and/or access the module and the FCC ID.
2.2 Industry Canada
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
This equipment is a Limited Certified Transmitter Module. If (1) the module’s IC ID is not visible when
installed in the host, or (2) if the host is marketed so that end users do not have straightforward commonly used
methods for access to remove the module so that the IC ID of the module is visible; then an additional
permanent label referring to the enclosed module: “Contains Transmitter Module IC: 25706-BIRDIRRA” must
be used. The host OEM user manual must also contain clear instructions on how end users can find and/or
access the module and the IC ID.