Operation Manual

Page 1 of 3

Taggle Systems Pty Ltd

Level 1, 101 Sussex Street

Sydney NSW 2000 Australia

+61 2 8999 1919

www.taggle.com.au

Birdirra Test Rig

Operation Manual

Contents

Revision History ................................................................................................................................ 1

1 Introduction ............................................................................................................................... 2

2 Test Rig Hardware..................................................................................................................... 2

3 Compliance Test Software ........................................................................................................ 3

Revision History

Revision

Date

Author

Details

1.0

18-May-2020

R Keaney

Initial Draft

PAGE 1
Birdirra Test Rig Operation Manual Contents Revision History ................................................................................................................................ 1 1 Introduction ............................................................................................................................... 2 2 Test Rig Hardware..................................................................................................................... 2 3 Compliance Test Software ....
PAGE 2
1 Introduction This document describes the operation of the Birdirra Test Rig (BTR). The BTR comprises a “bed of nails” style jig which connects to a single Birdirra Module using spring loaded pogo pins to facilitate connection of the module to a test computer, power supply and RF test instruments. The BTR is used both for Birdirra Manufacturing testing and Birdirra radio compliance testing.
PAGE 3
Compliance Test Software Open the provided software RfComplTest.exe It will prompt you to choose the serial port, select the port noted from the previous step. Note: If you have chosen the incorrect port the program will close. 1. Select “Set to BPSK Output” and hit “OK”. The module will begin to transmit modulated output continuously. 2. Select “Reset test mode” and hit “OK” to halt transmission. The board is powered through the USB.