Installation Guide

Page 11 of 54
5 Quick Start Guide
If have already reviewed this manual, this Quick Start Guide can act as refresher to ensure
the major activation steps have been completed.
Step 1- Locating and Mounting.
1. Locate the best position for reliable radio transmission
2. Fix the Cockatoo bracket to the desired location, ensuring the unit is vertical.
3. Mount the Cockatoo to the bracket and fix in place using the hose clamp.
Step 2 - Connecting
4. Wire up the sensor(s) to the connector(s) and confirm correct wiring.
5. Attach the sensor connector(s) to the Cockatoo and ensure connector is properly sealed.
• Confirmed seal by checking the head of the connector has separated slightly from
the body of the connector as shown below and is fully seated into the jack. Without a
properly connected sensor cable, the Cockatoo will stay in FLIGHT mode (and will
not wake up).
6. If required, connect the external power source and external antenna, ensuring a complete
and proper seal with the Cockatoo jacks.
7. Attach sensor to target location or device to be monitored.
Step 3 - Device Activation
8. Swipe NFC enabled device over the magnet symbol under the Taggle Logo.
9. Open NFC App and confirm that Cockatoo is in OPERATIONAL mode.
10. Wait 10 seconds
11. Confirm transmission receipt
For Taggle Byron Radio
o Confirm radio transmission receipt via the Survey Tool web page
▪ Australia http://survey.taggle.com.au/monitor
▪ Outside Australia https://survey.taggle.com.au/usa/monitor_test
For Myriota Satellite Radio
o If validating transmission, wait required time for satellite to pass and confirm
data receipt on your real time Internet connected device.
Step 4 - Document job completion information
12. Capture all relevant installation information on the paper or Aqualus or Videre Field
Operations Application (refer to Appendix for example of relevant information to capture)