Manualshelf

Installation Guide

ManualsBrandsTaggle Systems ManualsComputers & AccessoriesThe Taggle Cockatoo product range is a modular Radio Telemetry Unit (RTU) for connection to IoT devices. Models CK2-T1-I and CK2-T1-C incorporate a proprietary 922MHz DSSS radio which operates under FCC part 15.247 rules.
11121314151617181920
Page 19 of 54
9.2 Connectors
All Cockatoo’s are supplied with a male Sensor plug which mates with the female Sensor jack
on the base of the Cockatoo. External power and dual float switch variants of Cockatoo have
second male Power jacks fitted and are supplied with a matching female Power plug.
9.2.1 Wiring
Disassemble the connector into its three main
component parts as shown below
The sensor cable MUST be between 6mm to 8mm in
diameter, with the sheath stripped by 20mm and
each individual wire stripped to 5mm in length to
enable proper mating to the terminal block.
Component Part
Torque
M12 Knurl
0.4Nm
Screw terminal Block
0.2Nm
Pressure Screw with Sleeve Housing
0.8Nm to 1Nm
Sensor cable must be between 6mm and 8mm in diameter to ensure
proper seal within the connector.
9.2.2 Replacement Parts - Phoenix Contact
Connector
Supplier part number
Supplier URL
Sensor Connector
SACC-M12MS-5CON-PG9
www.phoenixcontact.com
Power Connector
SACC-M12FS-5CON-PG9
www.phoenixcontact.com
Figure 7 - Terminal
Block of Sensor
connector
Note each terminal is
individually numbered
Figure 5 - Side profile view of the complete connector
Figure 3 – Sensor
Connector Plug
Figure 6 - Explode view of connector
Figure 4 – Power
Connector Plug