Manualshelf

Installation Guide

ManualsBrandsTaggle Systems ManualsComputers & AccessoriesThe Taggle Cockatoo product range is a modular Radio Telemetry Unit (RTU) for connection to IoT devices. Models CK2-T1-I and CK2-T1-C incorporate a proprietary 922MHz DSSS radio which operates under FCC part 15.247 rules.
31323334353637383940
Page 34 of 54
4. Wait 60 seconds.
5. With the NFC Tool app open on the phone select READ again and tap the “a” location on
the Taggle logo. You should be presented with a dialog box and a tick symbol.
6. Wait 30 seconds.
7. With the NFC Tool app open on the phone select READ again and tap the “a” location on
the Taggle logo. You should be presented with a dialog box and a tick symbol. Once the
tick dialogue box disappears, click on the Record 1- Text section (red oval below), and
scroll down to the Value: section and confirm the following conditions.
• Device Mode ➔ reads “OPERATIONAL”
• Tx Count: ➔ reads any number greater than 1
• GPS LOCK: ➔ reads “1”
Troubleshooting
1. The sensor cable must first be attached to the Cockatoo before attempting the activation.
2. The sensor plug must have all wires correctly connected, refer Connector Jacks section
3. If the Cockatoo is in Device model = “FLIGHT” mode. Disconnect and reconnect the
sensor cable, and then repeat from Step 1 above.
4. If the Cockatoo has GPS LOCK does not equal to “1”. Wait 5 minutes and repeat steps
above starting from Steps 5.
Figure 14 - NFC Tools App and tapping sequence with Cockatoo