Manualshelf

Installation Guide

ManualsBrandsTaggle Systems ManualsComputers & AccessoriesThe Taggle Cockatoo product range is a modular Radio Telemetry Unit (RTU) for connection to IoT devices. Models CK2-T1-I and CK2-T1-C incorporate a proprietary 922MHz DSSS radio which operates under FCC part 15.247 rules.
31323334353637383940
Page 37 of 54
11.5 Step 5 - Attach the sensors and connectors
Purpose
Ensure proper and water-resistant seal between connector and Cockatoo Jack
Action
It is important for proper seal to be achieved between the sensor connector and the jack
for the connector to be fully tightened. As fully tightened connector will draw the connector
into the jack and as it tightens create a visible separation of the head of the connector
from the body, as shown in the image below
CORRECT
INCORRECT
Proper seal -
Note the zoomed in image and the separation of the
head from the body of the connector when tightened.
Insufficiently tightened
connector to the jack on the
Cockatoo
11.6 Step 6 - Test radio
Purpose
Once mounted reconfirm that the Cockatoo transmission can be heard.
Action
1. Repeat Step 2 now using the Cockatoo, along with connection to external power and
external antenna as appropriate.
11.7 Step 7 - Install – mount the sensor to the target equipment /location
Purpose
Install the sensor on the equipment/asset or in the desired location.
Action
1. Execute the required steps as described by the vendor of the Sensor
• If installing a Taggle provided sensor, consult the Appendix to this document for
installation advise or consult with your Reseller.