User Manual

Fast Tagging Station User's Guide
1. Plug the main power connector of the Fast Tagging Station to the main power supply
(this cable is not supplied as power supply cable depends on country standard)
CAUTION: If 110V, then use the power adaptor supplied. Figure 2
2. Connect the serial connector of the Fast Tagging Station to any serial port of the host
PC (use the serial cable provided)
3. Position the label roll as explained below:
3.1.2 Components Description
Figure 3: Fast Tagging Station overview
White reel
Label roll
Fixing bar
Cell
14/27 Revision 2.1 October 2007