User Manual

System Overview
July 2008 Revision 4.2 17/62
3.2 Brief L-SP2 Description
The components of the L-SP2 EAS system are contained within the L-SP2 pedestal. At
least two pedestals are required for each EAS gate. A set of pedestals is known as a gate and may
consist of several pedestals. Please see section 4 “Installation” for more information.
The L-SP2 is built in a one frame:
 A L-SP2 Electronics unit is used to control each pedestal. This electronics unit
generates the RF signal transmitted by the antennas and picks up the reply from the
RFID tag. If an activated RFID tag is detected, the electronics unit will activate the
alarm of the LED/buzzer board on the pedestal.
 These antennas are sensitive receivers used to detect the theft bit status of the RFID
tag as it passes through the EAS gate.
 A warning visual and audible device (LED/Buzzer board)
 A remotely accessible people counter equipped with a photoelectric sensor
To operate, the L-SP2 will only need a power supply cable.
In standard configuration the Ethernet interface is not provided. If the Ethernet version is
chosen then provide a second sheath for the Ethernet cable.