User Manual

Library Security Pedestal 2
20/62 Revision 4.2 July 2008
Figure 4: Ferrite clamp mounted on Ethernet cable
4.2 L-SP2 EAS System Components
The components included in the L-SP2 EAS System package are listed in Table 1
Table 1: L-SP2 EAS System Components
Quantity Description
1 L-SP2 Pedestal
8 40 mm Philips-head, countersunk screws with a diameter of 6 mm
8 8 mm plastic cement plugs
1 L-SP2 EAS System CD-ROM
1 RS 232 cable (system configuration)
4.3 L-SP2 Pedestal
4.3.1 Tools Required
The following tools are required during installation:
 Tape measure
 Square
 Drill with 4 mm, 8-mm and 19-mm bits
 Philips-head screwdriver
 Level
CAUTION: This equipment is intended for indoor use only under the conditions described in
this document. Should it be used outside these conditions cannot be guaranteed, and is not
recommended. Please read section 1 “Publishing Information” before installation or use.