User Manual

Configuration

July 2008 Revision 4.2 29/62

5.2.4 Synchronization by Wire

In this case the L-SP2 configuration settings are not to be changed. There will always be one

L-SP2 Master and others pedestals set as Slaves. Each pedestal is connected to the other using a

twisted pair cable.

Wire connection:

1. Unscrew the 4 screws to open the plastic panel

2. Unscrew the 9 screws to open the metallic cover

Figure 13: I/O port support

3. Use a thin sharp screwdriver to insert the wire terminal inside the I/O port 4 hole (please

see below Figure 14.

Figure

: Wire disposition

4. Repeat this sequence for each L-SP2 pedestal to connect each I/O port 4 together

5. Power up the whole system (every pedestals must be powered up) and check that the

synchronization process works properly

6. Replace the panels

5.3 Configuration of the Ethernet Interface

Don’t forget to power up your installation before carrying on the following steps

I/O port

support

1 2 3 4 GND

LSP2 #1

LSP2 #2

LSP2 #3

1 2 3 4 GND