User Manual

Library Security Pedestal 2
40/62 Revision 4.2 July 2008
The power can be lowered to avoid disturbing nearby RFID system (in such case check system
performance)
Antenna Sequence
It allows choosing antenna used by the EAS detector
Select (Top>Center>Bottom> Center) for standard operation or specifically an antenna for
diagnosis operations (Top, Center or Bottom)
Report Interval
If the same item passes through the gate several times, it will be reported only once every n
rounds (n is the number selected from the report interval section). A round duration corresponds to
Tscan, see 5.1, “Chip Configuration”.
AFI detection sensitivity
Turn it down in case too many false trigger occurs
AFI value
1 byte, enter the value in hexadecimal that matches your tag’s AFI
Alarm
 Normal: pedestal will report any detected item whether or not the memory is successfully
read
 Alarm on successful memory reading (Diagnosis): pedestal will only report detected items
with memory successfully read.
ISO15693 Uplink
Select Data coding mode: 1 out of 4 (26,48kbit/s), or 1 out of 256 (1,65kbits/s)
This parameter allows adjusting the transmitted data rate of each pedestal. However you should
not exceed 1.65kbits/s in order to comply with FCC standard certification. It is possible to increase
the transmitted data rate but only to carry on tests.
CAUTION: The L-SP2 pedestal has been tested to be compliant with FCC and CE rules
(with P = 4 W)