User Manual

L-SA4 SHD Antenna User's Guide
16/23 Revision 1.1 August 2010
Figure 3: Active Area in Standard Configuration
50 mm (2 in.)
50 mm (2 in.)
L-SA4
263 mm (10.5 in.)
288 mm (11.5 in.)
4.4 Specific Installation using the Mounting Kit
The L-SA4 SHD Antenna is provided with a mounting kit for specific installations. This mounting kit
can be used to orient the active face of the antenna depending on your application.
Figure 4: Using the Mounting Kit (Overview)
Figure 5: Using the Mounting Kit (Close-up View)
Flat-headed screw M4x12 + washer
Active face
This configuration reduces reading or writing performance (distance). For optimum performance,
the antenna must placed above the desk and not underneath.
Always ensure that metallic or conductive parts are located under the antenna.
Metallic or conductive parts must not be present in front of the active face of the antenna.
For best performance, always request an installation compliance agreement from TAGSYS
Custom Services regarding your specific installation.
The TAGSYS Antenna Tuning Kit Device may be required to verify the tuning of antennas for
a specific installation.